Ferroli RIMINI DP Serie Instrucciones De Instalación, Uso Y Mantenimiento página 54

Note: If the windowsill protrudes less than 20 mm, the gap above the emitter could be disre-
garded.
3. ELECTRICAL CONNECTION
The thermal emitter must be connected to the mains supply (230 V ~ 50 Hz) via its plug.
This appliance can be connected only to a supply with system impedance no more than
0.16 Ω. In case necessary, please consult your supply authority for system impedance
information.
In addition, the following warnings must be taken into account:
- The appliance must not be located below an electrical outlet or switch.
- The power line must be protected with a high-sensitivity differential device.
4. MOUNTING
The thermal emitter must be held by its handles, as shown in the following image:
54
EN
RIMINI DP
A73021554