Initial Setup - Sylvania LC320SS1 Manual Del Propietário

'4 Use _1/1_ to setectthe desired location setting, then
press OK.
_3
Initial Setup
This section will guide you through the unit's initial setting
which includes selecting a language for your on-screen menu
and autoprogram, which automatically scans and memorizes
viewable channels.
Before you be£in:
Make sure the unit is connected to antenna or cable.
2
After making all the necessary connections,
press _ to turn on the unit,
• It may take a few moments to turn on the unit for the
first time,
• [Initial Setup] menu appears automatically after the
unit is turned on,
Use A/¥ to select the on-screen tanguage from the
choices (English / Espafiol/Frangais) on the right side of the
TV screen,
3
Use A/¥ to select [Antenna] for TV channels or [Cable]
for CATV channels, then press OK.
• [Autoprogram] will begin.
• Select [Retail] store, the unit wilt be set up with
Note
predefined setting for retail displays, In this setting, the
power consumption may possibly exceed the limited
requirement of the ENERGY STAR ® qualification.
Select [Home], the unit is set to maximize the energy
efficiency for home setting and it can be adjusted
through a choice of picture and sound quality according
to your preference.
When the initial setup is completed, the lowest
memorized channel with the confirmation message of
the location setting will be displayed on theW screen.
If you are not receiving a signal from your cable service, contact the Cable
provider:
If you press _ or MENU during autoprogram, this setting will be canceled.
The initial autoprogram function can be executed for either [Antenna] or
[Cable] only once,When you change the connection (Antenna/Cable),
set [Autoprogram] again, ,,_ p.19
If there is no signal input from the antenna ter-minal and no operation for
several seconds after you turn on the unit, [Helpful Hints] appears, Follow
the instructions lisced on theTV screen.
You must set [Home] in step 4, Otherwise, the settings of picture and
sound quality you adjusced will not be memorized after- you turn offthe
unit.
g
_z
,>
(/:
i,:,ii!
q
;>
After an initial setup is completed...
• If you want to scan the channels automatically again,
[Autoprogram] "'_ p.19
• You can add the desired cable and analog channeis
unmemorized by autoprogram.
[Add Channels] ,,,_p.20
• If you want to change to another language.
[Language Selection] '"_ p.21
• If you want to change the location setting.
[Location] '"_"p.30
15
EN