Functional Description - Milwaukee 2725-20 Manual Del Operador

SYMBOLOGY
Volts
Direct Current
RPM
Safety Alert Symbol
Read Operator's Manual
Always wear eye protection and
hearing protection.
Always wear gloves and personal
protective equipment.
Always wear protective clothing
and footwear
Keep bystanders 50' away during use.
Minimum
50' 15m
Objects may be thrown or ricochet in
all directions.
Do not use in rain or wet locations.
Do not use blades or brush cutting
wheels.
UL Listing for Canada and U.S.
US
C

FUNCTIONAL DESCRIPTION

1. Trimmer pole
2. Front handle
3. Speed control button
4. Lock-off lever
5. Handle
6. Trigger
1
12
11
4
3
2
7. Trimmer head
8. Guard
9. Line blade
7
10. Spool tab
11. Line
12. Spool housing
8
9
10
Cat. No. ..................................................... 2725-20
Volts.............................................................. 18 DC
Battery Type .................................................M18™
Charger Type................................................M18™
RPM ........................................... 0 - 4600 / 0 - 5800
Cutting Line ................................ 25' x 0.080" spiral
................................................... 20' x 0.095" spiral
Replacement Line
WARNING
attached properly when trimming. Operating the
trimmer without the guard will cause serious
injury.
The guard is shipped unin-
s t a l l e d a n d m u s t b e
installed before use.
1. Line up the guard brack-
et with the holes in the
guard.
2. I n s e r t f o u r s c r e w s
through the guard and
into the bracket.
3. Tighten the screws
securely using the in-
cluded key.
WARNING
handle must be attached properly for use when
trimming. Using one hand could cause loss of
control and result in serious injury.
Installing the Front Handle
The front handle is shipped uninstalled
and must be installed before use.
1. Place the two nuts into the front
handle detents.
2. Insert one bracket into the handle.
5
3. Alight the front handle with the top
6
of the warning sticker, just above
the "Place Handle Here" marking.
4. Wrap the other bracket around the
back of the shaft.
5. Insert the two screws through the
lower bracket and into the side
handle.
6. Tighten the screws securely using
the included key.
4
SPECIFICATIONS
0.080".................. 49-16-2712
0.095".................. 49-16-2713
ASSEMBLY
Do not operate the tool without the guard in place. The guard must be
Installing the Guard
Do not operate the tool without the
front handle in place. The front