Idiomas disponibles
Idiomas disponibles
UTILISATION
NAVIGATION IN THE CONTROLS SCREEN
MANUAL UNBRINING
1
2 °C
Defrosting is used to remove ice on the evaporator surface.
The equipment performs an
temperatures or frequent door openings) a
To start the "Manual defrost" function, follow the steps below:
• make sure that the display is not locked. If it is, unlock it as indicated on the page 45.
Press the UPkey.
1
Press the SETkey: a start confirmation prompt screen appears.
2
Press the SET key again to start the function.
3
Two conditions may occur:
• The MAIN SCREEN appears and the icon
defrost is completed)
• The text "Manual Defrost" is coloured red: defrosting cannot start (the evaporator temperature is too high). Wait for the evap-
orator to cool down.
OVER TEMP.
1
2 °C
to lower the set point temperature by 2°C
The function is used
This function is useful when large quantities of food must be inserted into the equipment and frequent door openings could raise
the temperature in the cell, damaging the food.
To start the "Over temp." function, follow these steps:
• make sure that the display is not locked. If it is, unlock it as indicated on the page 45.
Press the UPkey.
1
Press the UP or DOWN keys to select the item OVER TEMP. (item highlighted in white= selected item).
2
Press the SETkey: a start confirmation prompt screen appears.
3
Press the SET key again to restart the function: a countdown appears on the MAIN SCREEN. The function will automatically
4
end when the countdown ends.
Manual Defrost
Over Temp.
Energy Saving
automatic
defrostcycle every 8 hours. In case of special operating conditions (e.g. very high
manual defrost
lights up: defrosting is in progress (turning off of the icon indicates that the
Manual Defrost
Over Temp.
Energy Saving
2
Controls
2
may be required.
Controls
3
time of 120 minutes
for a
47
Manual Defrost
Enter To Confirm
3
Over Temp.
Enter To Confirm
4
(factory set values, not changeable).
USE AND MAINTENANCE mod. PAPRIKA | Rev. 0
