Idiomas disponibles
Idiomas disponibles
BIKE COMPUTER MOUNT FOR IMPULSO RC INTEGRATED HANDLEBAR
The integrated handlebar provided with the Impulso RC models is compatible with bike computer mounts.
that are attached to the handlebar using two M5 screws.
Tighten the screws to the recommended torque of 2/3 Nm, as indicated on the handlebar.
Always use the safety strap supplied with the bike computer to fasten it to the handlebar.
WARNING!
Check that the mount is installed correctly before using the bike computer.
IMPULSO PRO AND COMP HANDLEBAR STEM AND BEND
The handlebar kit provided with the Impulso Pro and Comp frame is composed of a stem and bend designed specifically for this frame and uses Velomann
components.
The Impulso Pro and Comp frame uses the ICR head set system manufactured by Acros to route the cables within the handlebar and frame. The handlebar
is designed to integrate seamlessly with the head set.
During assembly, the cables enter the handlebar bend near the levers and exit under the stem, and then enter the frame through the spacers and head set.
The handlebar stem is available in lengths: 80 mm, 90 mm, 100 mm, 110
mm, 120 mm.
The height of this type of handlebar stem is adjustable by a specialist
retailer. Due to the importance and complexity of this component, please
consult your retailer for stem adjustment and to fully understand the
mechanisms and adjustment methods.
DANGER!
Always comply with the torque values specified on the stem.
Incorrect tightening may cause the component to malfunction or
break, causing the rider to lose control and fall.
Never use this product with incomplete or incorrect assembly. This
endangers not only the rider but also other road users.
WARNING!
Turn the handlebar left and right. Do not use the bike if there is any
evidence of abnormal steering (play in the steering or uneven resistance) or if any cracks or signs of damage are evident.
In the event of an accident or fall, the handlebar will almost certainly be involved and will be subjected to
high levels of stress and impact. In the event of any deep scratches or cracks, replace the components.
WARNING!
If the handlebar is damaged, stop using the Impulso Pro and/or Comp bike immediately. Do not use
the Impulso Pro and/or Comp bike until a specialist retailer has conducted a full inspection and, if
necessary, the handlebar has been replaced.
The gear/brake control levers are mounted on the handlebar using a clamp integrated into the lever.
Pay close attention to the recommended positioning of the levers and respect the positioning of the high grip
zone (image 1A). Consult the lever product handbook for the correct torque. To preserve the integrity of the
handlebar bend, do not exceed the maximum torque of 10 Nm.
1A
7
