Idiomas disponibles
Idiomas disponibles
EN
DECLARATION OF CONFORMITY
The manufacturer F.I.V.E. Bianchi S.p.A. located at Via delle Battaglie, 5 - 24047 Treviglio (BG), Italy, hereby declares that its products conform with standard
ISO4210. The products also conform with the provisions of Art. 50 of the Italian Highway Code (Italian Legislative Decree no. 285 of 30 April 1992, as
amended, and as amended by Art. 24/1 of Law no. 14 of 3 February 2003), as defined by Art. 2, paragraph 1, letter n) of the Agreement.
The complete list of product codes and the relative compliance information can be consulted under the "Declaration of Conformity" link at
https://www.bianchi.com/manuals/ .
GENERAL SAFETY WARNINGS
Please pay close attention to the following symbols.
DANGER!
indicates a potential danger which may cause serious injury or death if not avoided.
WARNING!
indicates practices and conduct to be adopted for safe product use.
INFORMATION!
Indicates additional information on how to use the product.
WARNING!
Please note that failure to comply with the warnings and provisions contained in this data sheet exempts the manufacturer of any liability.
INTENDED USE
ASTM CATEGORY 2 – Cyclocross, gravel, crossbike and trekking bikes, including the relative
Designed for use on surfaces as per Category 1 as well as unpaved roads with gravel, sand or similar surfaces (e.g., forestry roads, dirt
roads, paved hiking trails with few tree roots). The tyres remain in constant contact with the ground or only lose contact briefly due to
uneven ground. Drops are limited to 15 cm (6") or less.
FRAME AND FORK
The frame and fork of the Impulso RC, PRO and COMP models are 100% carbon fibre and designed to the specifications of Bianchi engineers to optimise the
sports performance and aesthetics, rigidity and lightness of the Impulso frame.
Internal cable housing and casing.
Standard Press-Fit 86.5 x 41mm bottom bracket.
The head tube is designed to house two 1"1/2 bearings.
The frame and fork are equipped with M12 thru-axles to attach the wheels.
The frame is compatible with electronic and mechanical shifting systems.
Maximum tyre width 42mm.
The frame is compatible with bottle cages mounted to the seat post and
the down tube.
The frame is compatible with brazed-on derailleurs only.
The frame is compatible with UDH - universal derailleur hangers - only.
The Impulso RC frame weighs 860g ± 5% (medium, 55).
The Impulso PRO frame weighs 960g ± 5% (medium, 55).
The Impulso COMP frame weighs 960g ± 5% (medium, 55).
The Impulso RC, PRO and COMP frames conform to UCI regulations.
WARNING!
The tyre measurement refers to the actual size and not to the image
on the cover.
4
Pedelec e-Bike pedal-assist
versions.
