Proxxon LGS/A Manual página 19

range can destroy the battery and increase the
risk of fi re.
Service
a) Never service damaged batteries. All mainte-
nance work on batteries should only be carried
out by the manufacturer or authorised custo-
mer service centres.
5 Commissioning and operation
Charging the battery (Fig. 2 and 3)
Caution!
Before starting up, read the warning instructions and
the labels attached to the charger and the battery!
Only charge the battery at an ambient temperature
of 10 to 40°C!
When delivered, the battery is partially charged and
must be charged completely before commissioning
the device. To do so, proceed as follows:
1. Insert the plug of the charger.
2. Insert battery 1 in the charger 2 as shown in Fig.
3. The yellow light-emitting diode 3 signals the
charging process. When completed, the green
light-emitting diode 4 lights up.
4. Remove the completely charged battery from
the charger.
5. Insert battery 2 As shown in Fig. 3 in the
housing opening of the device until it engages.
6. To charge, press the release buttons 2, pull out
the battery to the rear and carry out steps 1-
To protect the battery from harmful total discharge
while in operation, the charge status is permanently
monitored electronically and the device will switch
off before it reaches the critical discharge condition.
The battery will now need to be recharged. Do not
attempt to put the device back into operation with a
discharged battery!
The charging process can be interrupted at any time
and continued without damage to the battery.
Caution!
Drastically reduced operating times after the char-
ging process indicates that the battery needs to be
replaced!
If after inserting the battery into its designated
opening the light-emitting diode fl ashes instead of
glowing yellow continuously, the cause may be a
too high temperature, a defect, or the total dischar-
ge of the battery.
If the battery is too hot, the charging process will
start automatically after it cools down.
If, on the other hand, the battery has a normal
temperature but is totally discharged, the charger
will check if it still draws power or it if is already
defective.
If the battery can be recovered, the yellow light-
emitting diode will glow continuously after some
time, signalling the successful charging process.
If the yellow light-emitting diode fl ashes, the bat-
tery is defective and needs to be disposed of; see
also "Note on disposal within the EU" later on in
these instructions.
Operation
WARNING!
If the device starts up inadvertently during any
assembly, adjustment, maintenance or repair
work, serious injuries may result! You must
therefore remove the battery from the device
before carrying out these activities!
Clamping or changing the grinding pin (Fig. 4
and Fig. 5):
Before putting the cordless long neck straight grin-
der LGS/A into operation, the supplied grinding pin
must be mounted. It has a 6 mm diameter shaft
and is fi tted into the pre-assembled collet. Proceed
as follows:
›
1. Hold the fl at side of the output shaft with a size
10 mm wrench and slightly loosen the sleeve
nut 1 with a size 17 mm wrench
2. Remove any bits and cutters and insert the
shaft of the new bits and cutters into the collet
3. Tighten the sleeve nut with a size 17 mm
wrench. The output shaft must be countered
with a size 10 mm wrench as shown in Fig. 5.
- 15 -