Proxxon LGS/A Manual página 18

1 Collet ER 11 (Ø 6 mm)
1 Corundum grinding bit K 36
3 Technical data
Device:
Length:
Weight:
Fit:
Voltage:
Rotational speed:
Noise generation:
Grip vibration:
Charger:
Mains voltage:
Output voltage:
Charging current:
Battery:
Rechargeable lithium-ion battery
Nominal/charging voltage: 10.8 V / 12.6 V
Energy/Capacity:
4 Noise/vibration information
The information on vibration and noise emissi-
on has been determined in compliance with the
prescribed standardised and normative measuring
methods and can be used to compare electrical
devices and tools with each other.
These values also allow a preliminary evaluation of the
loads caused by vibration and noise emissions.
Depending on the operating conditions, the emissi-
ons that actually occur may deviate from the values
given above!
This applies in particular depending on the workpi-
ece to be machined and the insert tool (especially
its wear condition). Unsuitable workpieces or ma-
terials, poorly maintained tools, too high a feed rate
- 14 -
approx. 345 mm
(incl. battery)
approx. 310 mm
(without battery)
approx. 800 g
(incl. battery)
approx. 620 g
(without battery)
Ø 20 mm
10.8 V
7,000 – 23,000/min
< 70 dB(A)
2
< 2.5 m/s
100-240 V~,
50/60Hz
12.6 V
2 A
28.2 Wh / 2.6 Ah
or unsuitable insert tools can signifi cantly increase
the vibration load and noise generation.
To more accurately estimate the actual vibration and
noise load, also take the times into consideration
where the device is switched off, or is running but is
not actually in use. This can clearly reduce the vib-
ration and noise load across the entire work period.
Observe the following instructions to minimise vi-
bration exposure:
• Ensure regular and proper maintenance of your
tool
• Stop operation of the tool immediately if excessi-
ve vibration occurs!
• Unsuitable bits and cutters can cause excessive
vibration and noises. Only use suitable bits and
cutters!
• Take breaks if necessary when working with the
device!
Use and handling of battery-powered tool
a) Batteries should only be charged with the
chargers recommended by the manufacturer.
A charger suitable for a certain type of battery
poses a fi re hazard if used with other batteries.
b) Use only the designated batteries in the po-
wer tools. The use of other batteries can cause
injuries and pose a fi re hazard.
c) Keep unused batteries away from paper
clips, coins, keys, nails, screws and other
small metal objects which could bridge the
contacts. A short-circuit between the battery
contacts can cause burns or fi re.
d) If used incorrectly, the battery can leak flu-
ids. Avoid contact. In the event of incidental
contact, rinse with water. If the fl uid gets into
your eyes, seek medical assistance. Leaking
battery fl uids can cause skin irritations or burns.
e) Do not use a damaged or modified battery. Da-
maged or modifi ed batteries can behave unpre-
dictably and cause fi res, explosions or injuries.
f) Never expose a battery to fire or excessive
temperatures. Fire or temperatures above
130°C can cause an explosion.
g) Observe all charging instructions and never
charge the battery or battery-powered tool
outside the temperature range specified by
the operating instructions. Incorrect charging
or charging outside the approved temperature