Commissioning And Operation - Proxxon WAS/E Manual De Instrucciones

disc or saw blade) can cause excessive vib-
ration and noises. Only use suitable bits and
cutters!
• Take breaks if necessary when working with
the device!

6 Commissioning and operation

Caution!
Before cleaning, adjusting, service or repair,
disconnect the mains plug!
Always ensure your own safety! Despite its
compact size, the WAS/E cylinder sander is an
electric tool that harbours a certain level of risk.
Fitting the sanding or satin-fi nishing tool
(Fig. 2)
1. Slacken and unscrew Countersunk screw 2.
At the same time, press Lock button 1 to stop
Shaft 4 also being unscrewed.
2. Fully slide Sanding or satin-fi nishing cylinder
3 with the labelled side onto Output shaft 4.
3. Then screw Countersunk screw 2 into the
front shaft end and sensitively tighten. At the
same time, press Lock button 1 to stop the
shaft from also turning.
The sanding and satin-fi nishing tools supplied with your WAS/E cylinder sander include
1 x Grinding mop
cylinder (K 120,
Article 28562)
1 x Grinding mop
cylinder (K 240,
Article 28563)
1 x Satin-fi nishing
cylinder (fl eece,
Article 28565)
- 15 -
For coarse sanding work, surface cleaning and removing
paint residues
For fi ne sanding work e.g. sanding -down paintwork,
preparing surface treatment
For satin-fi nishing surfaces and preparing surface treatment