Idiomas disponibles
Idiomas disponibles
1. Connect the plug
EN
connector
2. Plug the smaller end of the USB cable
port
9
3. Plug the larger end of the USB cable into the USB port of a
compatible USB power source (e.g. USB power adaptor).
4. Plug the USB power adaptor into a mains socket for charging.
Charging starts automatically. Check the program indicator
lights
6
One indicator light = 25 % charged
Two indicator lights = 50 % charged
Three indicator lights = 75 % charged
Four indicator lights = fully charged
5. When charging is done, unplug the USB power adaptor from
the mains socket and disconnect the USB cable from the
charging port of the remote control.
6 Assembly
1. Open the hook-and-loop fasteners on the elastic straps
and guide the elastic straps through the side openings of the
neck mask
2. Close the hook-and-loop fasteners to secure the elastic straps
on the neck mask (see step 2 in Fig. B).
7 Operation
WARNING! RISK OF INJURY!
• Do not use the product for more than
15 minutes per session.
7.1 Carrying out the session
1. Fully charge the product and properly attach the elastic
straps
2. Thoroughly clean and dry your neck. Make sure it is free from
any make-up or dirt.
3. Sit or lie down and place the neck mask
4. Use the hook-and-loop fasteners on the ends of the elastic
straps to fit the neck mask comfortably on your neck.
11
of the neck mask
2
of the remote control
5
of the remote control.
for the charging progress:
(see step 1 in Fig. B).
1
(see chapter "Charging" and "Assembly").
3
with the
1
.
12
into the charging
4
over your neck.
1
3
