Idiomas disponibles
Idiomas disponibles
FR 200 • Operating Manual
Surface treatment
Make sure that surface to be treated is free from all obstacles.
• Hold the machine firmly with the steering rod.
• Lower the adjusting lever slowly.
• Move the machine forwards or backwards at a
• uniform speed.
• Increase or reduce the milling speed.
Do not cut too deeply!
Cutting too deeply does not boost performance. The machine must not float on the rotating
tool drum.
In the event of incorrect use, the milling capacity is reduced and the tool unnecessarily
stressed and worn.
The surface quality after machining depends essentially on the chosen tools and the fit-
ment method.
To obtain straight grooves, traces etc. a cord may be laid out on the floor or beam may help.
Levelling and coating removal work can also be performed with forward and backward
movements of the machine.
Before continuing to work surfaces that have already been treated, brush them down with a
broom and clean with a powerful vacuum cleaner.
Final operations
Stopping the machine
1. Set the adjusting lever upwards.
2. Switch off the drive.
3. Ensure that the machine remains stationary:
• Place the brake chocks in position.
4. Interrupting the energy supply:
• Interrupt the energy supply (models with electric drive).
• Close the fuel tap (gasoline version).
Switching off the dust extraction system
1. Switch the dust extraction system off.
2. Remove the suction tube from the machine.
Storing the machine
The machine should be cleaned immediately after each use!
1. Clean the machine.
2. Pour the contents of the fuel tank into a suitable container.
3. Store the machine in a dry place.
Secure when transporting with straps or with cable hooks at the transport eyelets provided!
CARE AND MAINTENANCE
Maintenance work
Always interrupt the energy supply before performing maintenance work!
Care and maintenance
19
