Idiomas disponibles
Idiomas disponibles
FR 200 • Operating Manual
Mounting the handle stopper
A. Insert the handle into the rubber sealing of stick and push as far as it will go.
B. Rotate the handle 90 degrees from the normal operating position. The hole on the back of the
stick must coincide with the threaded hole of the handle.
C. Fasten the screw thru the hole of the stick on the handle and tight it well. Use the hexagonal
key SW 5 which belongs to the machine.
D. Rotate back the handle to normal operating position and mount the plastic cap by pressing it
into the hole of the stick.
E. Regulate the height of the handle as desired and fasten the clamp on the top of the stick.
MACHINE DESCRIPTION AND BASIC MODE OF OPERATION
Construction of the machine
1. Handle bar Contains the controls of the machine.
2. Adjusting lever to raise and lower the tool drum:
• TOP: Drum in transport and idling position
• BOTTOM: Drum in working position
3. Handle grip Retaining and guide handle for the
machine.
4. Guide handle Retaining and guide handle for the
machine.
5. Motor switch
• Switch for electric motor. 2 positions: (ON I , OFF 0)
6. Transport hooks
7. Dust extractor Connection for the dust extraction
system
8. Supporting wheel 2 fixed rollers to guide the ma-
chine.
9. Belt guard
• The belt guard must only be removed for repair and
maintenance work.
• The machine must, under no circumstances, be oper-
ated without the belt guard in position.
10. Drive motor 3 drive types:
• Single phase motor (115V, 230V)
• Three-phase motor (400V)
• Petrol engine
A
D
Machine description and basic mode of operation
B
E
3
10
C
2
10
1
11
3
4
2
1
5
6
7
8
9
11
