Idiomas disponibles
Idiomas disponibles
4 Cooling
41
5 Cleaning and maintenance
44
46
48
10
41 Press the on/off button to turn off the
appliance.
42 Unplug grill from wall outlet.
43 Allow to cool for at least 2 hours.
To avoid accidental burns, allow grill to cool
42
thoroughly before cleaning.
2 H
2 H
43
44 Before cleaning, unlock and remove the
plates to avoid damaging the cooking sur-
face. The drip tray and the cooking plates are
dishwasher safe.
45 The appliance and its cord cannot be placed
in the dishwasher. The heating elements,
visible and accessible parts, should not be
45
cleaned after removing the plates. If they are
very dirty, wait until the appliance has com-
pletely cooled down and clean them with a
dry cloth. If you do not want to clean them in
a dishwasher, you can use warm water and a
little dishwashing liquid to clean the cooking
plates, then rinse thoroughly to remove any
residue. Dry thoroughly using a paper towel.
46 Do not use metallic scouring pads, steel
47
wool or any abrasive cleaners to clean any
part of your grill, only use nylon or non-
metallic cleaning pads.
Empty the drip tray and wash in warm water
and a little dishwashing liquid, dry thoroughly
using a paper towel.
47 To clean the grill cover, wipe with a warm,
wet sponge and dry with a soft, dry cloth.
49
48 Do not immerse the body of grill in water or
any other liquid.
49 Always make sure grill is clean and dry be-
fore storing.
50 Any other servicing should be performed by
an authorized service representative.
50
Trooble shooting
Problem
Cause
The screen switches to: visual display with Err +
BIP BIP
Preheating not respected.
Switching "ON" of the appliance or starting an
automatic cooking cycle with food between
plates. The manual mode is automatically
activated.
The screen switches to: visual display with Err +
BIP BIP
Preheating time not completely done. Grill has
been opened and food inserted on plate before
end of preheating.
The appliance has been kept open for too long
while cooking.
Er07 à Er10
The appliance has been idle too long after the
end of preheating or keep warm.
Appliance failure.
The display remains on the preheating with
picto waitfood
Your food is thicker than 1,5 inches.
The display shows "OK"
You have not completely opened the grill to
place the food.
Not sensing the food. The food thickness too
thin, "OK" is flashing.
Appliance failure :
Appliance stored or used in a room that is too
Er01 to Er06
cold.
Appliance over heating.
Tip, especially for meat: the cooking results on the preset programs may vary depending on origin, cut and quality of
the food being cooked, the programs have been set and tested for good quality food.
Similarly, the thickness of the meat has to be taken into account during cooking; you cannot cook food that is thicker
than 4 cm.
en
Solution
- Choose the temperature setting by pressing "+"
and "-" buttons and then press OK.
Allow to cook, but you must monitor the
cooking (manual mode). Temperature can be
adjusted by "+" and "-" buttons.
- Switch off and open completely the appliance,
remove the food, close the appliance properly,
select a cooking program and press OK. Wait
until end of preheating (Preheating indicator
lighted fix).
Allow to cook, but you must monitor the
cooking because it is in manual mode.
Temperature can be adjusted by button.
or
Open the appliance, remove the food, close
the appliance properly, and wait until end of
preheating (Preheating indicator lighted fix).
Unplug the appliance and wait few minutes.
Plug again your appliance and switch ON.
Unplug the product and contact your customer
service.
Food must not be thicker than 1,5 inches.
Completely open the grill then close it.
Confirm the start of the cooking by pressing the
"OK/START" button.
Unplug the appliance and wait few minutes.
Plug again your appliance and switch ON.
If the problem persists, contact your Customer
service.
11
