Trooble Shooting - TEFAL OPTIGRILL DELUXE GC707 Instrucciones De Uso

Trooble shooting

Problem
Buttons + flashing
+ led lighted
After closing the appliance with food
between plates, the appliance turns itself
to manual mode with flashing
discontinue bip then after
few seconds, it heats in manual mode under
270°C
The appliance stops during the cycle of
preheating or cooking.
The 6 indicator lights flashing
+ one of the button flashing
+ discontinue bip
The appliance no longer beeps
After the preheating , I have put my food on
the grill but cooking cycle does not start.
The indicator stays on
and button flashing
The 6 indicator lights flashing
+ one of the buttons flashing
+ discontinue or continue bip
Tip, especially for meat: the cooking results on the preset programs may vary depending on origin, cut and quality of
the food being cooked, the programs have been set and tested for good quality food.
Similarly, the thickness of the meat has to be taken into account during cooking; you cannot cook food that is thicker
than 4 cm.
64
Cause
Preheating not respected.
Switching "ON" of the appliance or starting an
automatic cooking cycle with food between
plates. The manual mode is automatically
activated.
Preheating time not completely done. Grill
+ +
has been opened and food inserted on plate
before end of preheating.
The appliance has been kept open for too
long while cooking.
The appliance has been idle too long after
the end of preheating or keep warm.
Appliance failure.
Your food is thicker than 4 cm.
You have not completely opened the grill to
place the food.
Not sensing the food. The food thickness too
thin, "OK" is flashing.
Appliance failure :
Appliance stored or used in a room that is too
cold.
Appliance over heating.
Solution
• 2 possible options:
- choose the temperature setting by pressing the
button and then press OK. Allow to cook, but
you must monitor the cooking (manual mode).
Temperature can be adjusted by
- Open completely the appliance, remove the
food, close the appliance properly, select a
cooking program and press OK. Wait until end of
preheating (Preheating indicator lighted fix).
Allow to cook, but you must monitor the cooking
because it is in manual mode. Temperature can be
adjusted by button.
or
Open the appliance, remove the food, close the
appliance properly, and wait until end of preheating
(Preheating indicator lighted fix).
Unplug the appliance and wait few minutes.
Plug again your appliance and switch ON.
Unplug the product and contact your customer
service.
Food must not be thicker than 4 cm.
Completely open the grill then close it.
Confirm the start of the cooking by pressing the
button.
Unplug the appliance and wait few minutes.
Plug again your appliance and switch ON.
If the problem persists, contact your Customer
service.
button.