cecotec POWER ESPRESSO 20 STEEL PRO LATTE Manual De Instrucciones página 24

ENGLISH
6. The machine will dispense coffee according to your selection and automatically turn off
the buttons indicating that the cycle is finished.
NOTE: for a short result, use the 1-cup filter. For a long result, use the 2-cup filter. Be sure to
clean the milk spout after each use to prevent the milk from drying out and causing future
odours. Please refer to the cleaning instructions section.
Latte coffee preparation
1. Follow the same first three steps as specified in the Cappuccino preparation section.
2. Press the Latte button once for a short coffee size. While coffee is being dispensed, the
button will illuminate blue.
3. Press the Latte button twice to obtain a longer result if desired. While coffee is being
dispensed, the button will illuminate green.
4. The machine will dispense coffee according to your selection and automatically turn off
the buttons indicating that the cycle is finished.
NOTE: for a short result, use the 1-cup filter. For a long result, use the 2-cup filter. Be sure to
clean the milk spout after each use to prevent the milk from drying out and causing future
odours. Please refer to the cleaning instructions section.
How to adjust the coffee size for Espresso, Cappuccino, and Latte
The machine allows you to customise the size of the different modes.
Adjusting the Espresso size
1. Press and hold the Espresso button for 3 seconds. The light will start flashing green,
indicating that the machine is ready to reconfigure the quantities.
2. Press the Espresso button once again (twice if you intend to reset the long mode) and
coffee will start to come out.
3. Press the Espresso button again when you have drawn off the desired amount of
espresso. The machine will beep three times to indicate that the settings have been
successfully saved.
NOTE: the possible size of coffee that can be stored is between 20 and 200 ml.
Adjusting the Cappuccino size
1. Press and hold the Espresso button for 3 seconds. The light will start flashing green,
indicating that the machine is ready to reconfigure the quantities.
2. Press the Cappuccino button once (twice if you intend to reset the long mode) and milk
will start to come out.
3. When you have extracted the desired amount of milk, press the Cappuccino button again.
46 POWER ESPRESSO 20 STEEL PRO LATTE
The machine will start to dispense coffee.
4. Press the Cappuccino button again when you have drawn off the desired amount of coffee.
The machine will beep three times to indicate that the settings have been successfully
saved.
Adjusting the Latte size
1. Press and hold the Espresso button for 3 seconds. The light will start flashing green,
indicating that the machine is ready to reconfigure the quantities.
2. Press the Latte button once (twice if you intend to reset the long mode) and milk will start
to come out.
3. When you have extracted the desired amount of milk, press the Latte button again. The
machine will start to dispense coffee.
4. Press the Latte button again when you have drawn off the desired amount of coffee. The
machine will beep three times to indicate that the settings have been successfully saved.
NOTE: the possible size of coffee that can be stored is between 20 and 200 ml. The milk
dispensing time varies in the range of 6 to 60 seconds.
Reset the default amount
To reset the amount in any mode, press and hold the Espresso and Cappuccino buttons for 5
seconds. The machine will return to its original default settings.
Warning for lack of water
For low water warning, the Espresso, Cappuccino, and Latte buttons will flash green
simultaneously. Once the water shortage warning is activated, proceed as follows:
1. Refill the water tank with water at room temperature.
2. Place an empty cup under the brewing head and point the milk spout into the cup.
3. Press one of the Espresso, Cappuccino, or Latte buttons. The machine will start dispensing
hot water.
4. Once the hot water has finished flowing out, it means that the internal pipes of the coffee
machine are full and clean. The buttons will light up again and the machine will be ready
for use again.
WARNING: never press any of the buttons after the low water warning has been triggered
without refilling the water tank.
Standby mode
The machine will enter standby mode after 15 minutes of non-use. All buttons will turn off. In
case you want to use it again, press the power button and proceed as desired.
ENGLISH
POWER ESPRESSO 20 STEEL PRO LATTE 47