Beurer LB 37 Manual De Instrucciones página 18

Humidificador de aire
Ocultar thumbs Ver también para LB 37:
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
Problem
The mist has a strange smell The device is new.
Strange noise
Mist escapes underneath
the water tank
The LED lights up red
although the tank is full
11. DISPOSAL
For environmental reasons, do not dispose of the device in the household waste at the end of its useful life.
Dispose of the unit at a suitable local collection or recycling point. Dispose of the device in accordance with
EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you have any questions, please contact
the local authorities responsible for waste disposal.
12. TECHNICAL SPECIFICATIONS
Dimensions (LxWxH)
Cable length
Mains voltage/frequency
Nominal power
Room size
Capacity
Evaporation output
Signs and symbols
Volume
13. WARRANTY / SERVICE
Further information on the warranty and warranty conditions can be found in the warranty leaflet supplied.
Cause
Stale or dirty water.
The water tank is not positioned
correctly on the base unit.
There is too little water in the water
tank.
The device is not level and unsta-
ble.
The water tank is not positioned
correctly on the base unit.
The device evaluates the water
level incorrectly due to a fault.
approx. 21 cm x 11 cm x 25,5 cm
approx. 1.5 m
100 – 240 V AC / 50/60 Hz
max. 20 W
up to 20 m²
approx. 2 litres
200 ml/hour
The unit is double-protected and thus corresponds to protection class 2.
approx. 35 dB
Solution
Remove the water tank, turn the screwed plug and
remove it.
Air the open, emply water tank in a cool, dry place
for twelve hours.
Empty the base unit and the water tank and clean
them thoroughly.
Fill the water tank with fresh water.
Lift up the water tank and position it correctly on
the base unit.
The tank should sit tightly on the base unit.
Fill the water tank.
Place the device on a firm, level surface.
Lift up the water tank.
Check whether the join between the base unit and
water tank is clean.
Clean if required.
Position the water tank correctly on the base unit.
The tank should sit tightly on the base unit.
Restart the device.
18
loading