Beurer LB 37 Manual De Instrucciones página 17

• Clean the ultrasound membrane using the cleaning brush.
• Rinse the base unit twice with clean, fresh water.
Cleaning inside the base unit
• Dip a damp, soft cloth briefly in descaling solution.
• Use the cloth to wipe the inside of the base unit.
• Carefully pour some clean, fresh water into the base unit.
• Empty the water from the base unit via the side edge.
• Repeat the process using clean, fresh water.
Descaling the water tank
• Half-fill the water tank with descaling solution.
• Tightly close the water tank using the screwed plug.
• Shake the water tank by rocking it back and forth several times.
• Empty the descaling solution completely.
• Repeat the process twice using clean, fresh water.
9. ACCESSORIES AND REPLACEMENT PARTS
Tip!
If the water is hard, we recommend using the optional anti-limescale filter.
Anti-limescale filter (optional).
Note
• If the anti-limescale filter does not prevent limescale build-up, or if white deposits form on or in the device, the anti-
limescale filter should be replaced.
• The service life of the anti-limescale filter is around two to three months at most.
• If the device is not used for a relatively long time, the anti-limescale filter must be removed from the water tank and
dried out.
Fitting the anti-limescale filter
• Lift the water tank and rotate it.
• Open the screwed plug on the water tank.
• Screw the anti-limescale filter onto the screwed plug on the inside.
• Tightly close the water tank using the screwed plug.
Replacement items
For replacement parts and additional items visit www.beurer.com or contact the corresponding service address in your
country (according to the service address list).
Replacement parts and additional items are also available from retailers.
Item
Beurer by Taoasis "Vitality" aroma oil (10 ml)
Beurer by Taoasis "Relax" aroma oil (10 ml)
10 aroma pads
Anti-limescale filter (optional)
10. WHAT IF THERE ARE PROBLEMS?
Problem
No LED display
Red LED
No mist is produced
Cause
The mains cable is not plugged in.
The water level is too low; the water
tank is empty.
The LED display lights red .
The LED display does not light up.
Item number
681.30
681.32
163.801
163.803
Solution
Connect the plug.
Fill the water tank.
Fill the water tank.
17