Idiomas disponibles
Idiomas disponibles
OPERATION
WARNING:
Do not allow familiarity with this product to make
you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when
you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery
pack will prevent accidental starting that could
cause serious personal injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this prod-
uct. The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
„ Cutting all types of wood and wood products, thin sheet
metal, plastics, and laminates
OVERLOAD PROTECTION
When the tool is forced or overloaded, the Li-ion battery pack
will automatically shut off the tool. To reset the tool, slide
the switch OFF, and then back ON to resume operation. If
the tool still does not resume operation, remove and reinsert
the battery. Do not force the tool.
HIGH TEMPERATURE PROTECTION
Li-ion battery packs are equipped with a high temperature
protection feature that automatically deactivates the tool
when it is overheated. Slide the switch to OFF, and allow the
battery to cool. To resume operation, slide the switch ON.
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 11.
To install:
„ Align raised ribs on battery pack with the grooves inside
the tool.
„ Make sure the latches on each side of the battery
pack snap in place and battery pack is secured before
beginning operation.
To remove:
„ Depress the latches on each side of the battery pack.
ON-OFF SWITCH AND VARIABLE SPEED DIAL
See Figure 2, page 11.
The variable speed dial delivers higher speed when rotated
to a larger number and slower speed when rotated to a
smaller number.
To turn the tool ON, slide the switch toward the front of the
tool. To turn it OFF, slide the switch towards the rear of the
tool and allow the blade to come to a complete stop.
VARIABLE SPEED DIAL
See Figure 2, page 11.
The speed selector dial, located on the top of the tool,
allows the saw to operate at different maximum speeds. The
maximum speed can be adjusted before or during operation.
To change the maximum speed during operation, hold the
saw in a normal operating position, and rotate the speed
selector dial to the desired speed setting. To change the
maximum speed prior to operation, rotate the speed selector
dial to the desired setting and slide the switch button towards
the front of the tool to operate the saw.
SETTING
OPERATION
A
Saw runs at reduced speeds until blade
engages workpiece. The saw speed will
increase automatically to provide the most
efficient cut.
1-2
Slow speeds are ideal when minimum speed
and power is required, for example, starting
cuts.
3-4
Medium speeds are suitable for cutting hard
metals, plastics, and laminates.
5-6
Maximum speeds produce best results when
maximum power is required, for example,
cutting wood. Soft metals such as aluminum,
brass, and copper may also require high
speeds.
6 – English
