Idiomas disponibles
Idiomas disponibles
Safety Instructions
• Only trained and authorized operator shall be permitted to operate the truck.
• Operator must wear helmet, working shoes and uniform
• Do wash the inner of the truck, do not place the truck outdoors and exposed to the rain.
• Fire extinguisher shall be equipped at the work site. Users can choose truck equipped with
fire extinguisher. Driver and manger should be familiar with the fire extinguisher position and
application method.
• Whenever you find the forklift abnormal, stop the truck, put on the DANGEROUS or FAULT sign
to the truck, remove the key, and report to the managing person. Only after eliminating the fault
can you use the truck.
• The controller equips with energy accumulator, do not touch between B+
and B- to avoid electric injury. If you need check or clean the controller, connect load(like
contactor coil or horn or bulb or resistance) between controller B+ and B- to discharge the
controller capacity.
Only trained and authorized operator shall be permitted to operate the truck.
• Do not use truck under the weather of sand, snow, thunder, storm, typhoon, etc.
Avoid using the truck when the wind speed is larger than 5m/s.
• Cause the wheels of pallet truck is small, it is not allowed to run on the street, and only for
driving in specified stacking place.
• When handling bulky loads, which restrict your vision, please operate the
machine in reverse or have a guide.
• Do not drive the truck when the forks in high position.
• Goods are not allowed to deviate the fork center, when goods is deviating the fork center, turn
or pass uneven road, you are easily to fall. Meanwhile, possibility of turnover will increase.
• Wipe off the oil, grease or water on the soleplate, foot pedal and control lever.
Stability
Stability is guaranteed if your truck is used properly in accordance with its
intended purpose. Common reasons for a loss of truck stability include:
• Emergency stops or sharp turns
• Driving with a raised load or a load handling device
• Turning the vehicle around on or driving across a slope
• Driving up or down a slope with the load pointing downhill
• Driving with a wide load
• Carrying a swinging load
• Driving near the edge of a ramp or up steps
• Tilting the mast forward while carrying a
raised load
• Driving on uneven surfaces
• Overloading the truck
• Carrying bulky loads in strong winds
• When carrying liquid, its centre of mass inside the container may shift due to
inertial force (such as when pulling away, braking or turning)
A
5
REV. 09/2022
