SFS isoweld 3000m Manual De Usuario página 45

Start-up
Before working with the induction welding tool, the project parameters must
be entered into the display. The parameters required are the waterproof
membrane material and thickness. The following options are available:

Note: the settings (parameters) used last will be loaded. It is possible to either
adopt these settings or make new selections of the following settings.
Waterproof
membrane
material
PVC
TPO 0.9-1.1/35-44 1.2-1.4/45-59 1.5-1.7/60-69 1.8-2.0/70-79 2.1-2.3/80-90
EPDM
Display examples
For changing the settings, proceed as follows:
The position display is on the choice of the waterproof membrane material ( first line).
1. Press the button
2. Press the
L
material is displayed.
3. Confirm the selection by pressing the
4. Press the
M
5. Press the
OK
6. Press the
L
7 . Confirm the selection by pressing the

The parameters have now been set and stored.
Waterproof membrane thickness (mm/mil)
. ≥ appears and flashes.
OK
button or press the
button to go to the waterproof membrane thickness selection.
button. ≥ appears and flashes.
or button to determine the waterproof membrane thickness.
M
button until the required waterproof membrane
M
button.  appears.
OK
button.
OK
45