Idiomas disponibles
Idiomas disponibles
Attaching auxiliary handle
CAUTION!
Risk of severe injuries.
Work only with the auxiliary
¾
handle [2] attached!
▸
Screw off the auxiliary handle [2] from the angle
grinder and firmly tighten it on the left or right side
of the protective extraction hood [12].
Attaching dust extraction
CAUTION!
Risk of severe injuries.
Only work with a suitable dust
¾
extraction system: Connect a suitable
vacuum cleaner (class M) to the
suction connection [5].
▸
For optimum extraction, use the connection sleeve
0702 400 249.
We recommend the use of an antistatic Ø 35 mm
suction hose.
Attaching accessories
WARNING!
Risk of severe injuries.
Pull the mains plug out of the plug
¾
socket before all tooling operations.
The machine must be switched off
¾
with the spindle stationary.
Attaching diamond-cut-off wheel
Disassemble the protective extraction
hood [12] and foot part [11] (fig. A)
▸
Push the slider [10] in the direction of the arrow
and swivel the protective extraction hood [12] in
the direction of the arrow as is shown.
▸
The protective extraction hood [12] can be removed
from the foot part [11] in the position shown.
Attaching the diamond cut-off wheel to the
angle grinder (fig. D)
▸
Press in the spindle locking knob [4] and turn
the spindle [20] until the spindle locking knob
noticeably engages.
16
▸
Put support flange [19] (scope of delivery of the
angle grinder) onto the spindle. It is fitted correctly
when it cannot be turned on the locked spindle.
▸
Put the spacer sleeve [18] onto the support
flange [19].
▸
Lay the diamond-cut-off wheel [17] onto the
spacer sleeve [18]. Ensure the correct direction of
rotation. The direction of rotation is indicated by
arrows on the diamond cut-off wheel and on the
protective extraction hood.
▸
Ensure that the 2-hole clamping nut [16] and the
spindle [20] of the angle grinder match:
The inscription on the 2-hole clamping nut and the
thread indication on the rating plate of the angle
grinder must correspond with one another (M14
or 5/8").
▸
Screw on the 2-hole clamping nut [16].
▸
Press the spindle locking knob [4] and hold it
down.
▸
Firmly tighten the 2-hole clamping nut [16] using
the 2-hole spanner [15].
Protective extraction hood [12] foot
part [11] assembly
▸
Insert the 2 bolts of the protective extraction
hood [12] into the guides of the foot part [11] as
is shown (fig. B).
▸
Swivel the protective extraction hood [12] and
the foot part [11] into one another until the
slider [10] engages and both parts are con-
nected to one another.
▸
Ensure that the connection is secure.
Operation
WARNING!
Risk of severe injuries.
Always guide the device with both
¾
hands on the main handle of the
angle grinder and on the auxiliary
handle [2].
▸
Setting the desired cutting depth:
Loosen the clamping screw [6] and set to the
desired cutting depth on the scale; tighten the
clamping screw [6] again.
▸
Set the protective guard with the foot part [11]
onto the workpiece.
▸
Switch on the machine and wait until full speed
has been achieved.
▸
Actuate the unlocking lever [3.] Slowly guide the
machine downwards up until the stop.
The diamond cut-off wheel penetrates into the
3
material.
