Metabo G 400 Instrucciones De Manejo página 10

en ENGLISH
8. Accessories
Use only genuine Metabo accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating instruc-
tions.
Fit accessories securely. Secure the machine if it is
operated in a bracket. Loss of control can cause
personal injury.
A Collets (including nut)
dia. 3 mm = 6.31947
dia. 1/8" = 6.31948
dia. 6 mm = 6.31945
dia. 1/4" = 6.31949
dia. 8 mm = 6.31946
B Clamping frame 6.28329 for clamping during
work with flexible shafts, including:
C Clamping bracket 6.27107 for safe securing to
the work bench (tighten clamping screw).
D Mounted points for fine grinding work on metal.
E Cutting wheel for fine cutting and grinding work on
metal.
For a complete range of accessories, see
www.metabo.com or the catalogue.
9. Repairs
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
If you have Metabo electrical tools that require
repairs, please contact your Metabo service centre.
For addresses see www.metabo.com.
You can download spare parts lists from
www.metabo.com.
10. Environmental Protection
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Packaging materials must be disposed of according
to their labelling in accordance with municipal
guidelines. Further information can be found at www.metabo.com in the "Service" section.
11. Technical specifications
Explanation of details on page 3. Subject to
changes serving technical progress.
n = No-load speed (maximum speed)
n = On-load speed
1
P = Nominal power input
1
P = Power output
2
D = Maximum grinding wheel diameter
max
T = Maximum thickness of bonded grinding
max
wheels
d = Collet bore of the collet chuck
m = Weight without mains cable
L = maximum insertion depth
max
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
10
Emission values
Using these values, you can estimate the
emissions from this power tool and compare these
with the values emitted by other power tools. The
actual values may be higher or lower, depending on
the particular application and the condition of the
tool or power tool. In estimating the values, you should also include work breaks and periods of low
use. Based on the estimated emission values,
specify protective measures for the user - for
example, any organisational steps that must be put
in place.
Vibration total value (vector sum of three directions)
a = Vibration emission level
h, SG
K = Uncertainty (vibration)
h,SG
U = Unbalance
M
Typical A-effective perceived sound levels::
L = Sound pressure level
pA
L = Acoustic power level
WA
K , K = Uncertainty
pA WA
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!