Idiomas disponibles
Idiomas disponibles
17024946_0409 PowerMaxx.book Seite 13 Dienstag, 14. April 2009 8:36 08
11 Accessories
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For the dealer to select the correct accessory, he
needs to know the exact model designation of
your power tool.
See page 4.
A Quick-clamping chuck.
Fitting: unscrew protective cap (1). (To
remove a tight protective cap, insert a
metal pin (diameter 4 mm) in the protective
cap bore to assist removal). Screw the
quick-clamping chuck onto the spindle
thread. The quick-clamping chuck can be
tightened (and released again) with an
open-jawed spanner, a/f 17.
B Angle screwdriver attachment.
Fitting: mount on the aluminium neck of the
machine and tighten the clamping screw
with the enclosed Allen key.
C Battery pack
D Adapter
E Chargers
F Bit box
G Bit clamping bush
12 Repairs
Repairs to electrical tools must be
carried out by qualified electricians
ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault with the
power tool.
13 Environmental Protection
Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that
can be recycled.
These instructions are printed on chlorine-free
bleached paper.
Battery packs must not be disposed of with regular
waste! Please return faulty or used battery packs
to your Metabo dealer!
Do not throw battery packs into water.
ENGLISH
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline 2002/
96/EC on used electronic and electric equipment
and its implementation in national legal systems,
used power tools must be collected separately
and handed in for environmentally compatible
recycling.
14 Technical Specifications
Explanatory notes on the information on page 2.
Changes due to technological progress reserved.
PowerMaxx:
U
=
Voltage of battery pack
n
=
No-load speed
Tightening torque for screwing:
M
=
soft screwing application (wood)
A
M
=
hard screwing application (metal)
B
M
=
adjustable torque (with torque
C
control)
M
=
maximum tightening torque. When
D
used as a screwdriver.
Max. drill diameter:
D
=
in steel
1 max
D
=
in softwood
2 max
m
=
weight (with battery pack)
G
=
spindle thread
Vibration total value (vector sum of three
directions) determined in accordance with
EN 60745:
a
= Vibration emission value
h, D
(drilling into metal)
a
= Vibration emission level
h, S
(screwing without impact)
K
= Uncertainty (vibration)
h, ...
The vibration level specified in these instructions
has been measured using a procedure standard-
ised in EN 60745 and can be used for comparing
power tools with one another. It is also suitable for
a provisional estimate of the vibratory load.
The specified vibration level applies to the main
applications of the power tool. However if the tool
is used for different applications, with different
accessories or poorly maintained, the vibration
emission may differ. This can considerably
increase the vibratory load over the entire working
period.
For an accurate estimate of the vibratory load,
times in which the machine is switched off, or
when it is running but not actually in use, should
also be taken into consideration. This can consid-
erably reduce the vibratory load over the entire
working period.
Define additional safety measures to protect the
operator against the effect of vibrations, e.g.:
ENG
13
