Idiomas disponibles
Idiomas disponibles
To clean the product
•
Always clean all the equipment after use. Use a
vacuum cleaner.
•
Do not use a high-pressure washer to clean the
product.
•
Keep the air openings clean and clear to make
sure that the product always has sufficiently cool
temperature.
To replace the batteries in the remote
control
1. Remove the 6 screws.
2. Carefully lift the top (A) of the battery cover and
remove it. The battery cover is attached with hinges
at the bottom (B).
B
To reset the product after an operation
failure
1. Move the product down to the ground or onto a
pallet.
2156 - 001 - 08.02.2024
3. Replace the batteries. For the correct battery type,
refer to
4. Attach the hinges at the bottom of the battery cover
and push down the top of the battery cover.
5. Install the 6 screws and torque them to 1 Nm.
To lubricate the steel ropes
1. Remove the steel wire ropes from the product. Make
sure that you put the steel wire ropes on a clean
surface.
2. Clean the steel ropes with a lint-free cloth.
3. Lubricate the steel wire ropes
A
Troubleshooting
2. Set the ON/OFF switch to OFF.
3. Push the OFF button on the remote control.
4. Wait 15 seconds and then set the ON/OFF switch to
ON and start the remote control.
Technical data on page 18 .
CAUTION:
Do not lubricate the steel
wire ropes with lubricants that contain
molybdenum disulphide (MoS2) or PTFE.
Use a standard multi-purpose oil or grease.
15
