Idiomas disponibles
Idiomas disponibles
Introduction
WARNING:
safety chapter before you use the product.
WARNING:
clamps on the steel wire ropes are
tightened.
To do before you operate the product
1. Read the operator's manual for this product, the EBE
900 V shot blaster, and the dust collector carefully
and make sure that you understand the instructions.
2. If a generator is used as a power source for the
product, read and understand the operator's manual
of the generator.
3. Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
4. Do a visual inspection of the product. Refer to
a visual inspection on page 11 .
5. Make sure that the product is assembled correctly
and is not damaged.
6. Make sure that all bolts, screws and nuts are
tightened.
7. Do daily maintenance. Refer to
schedule on page 14 .
8. Install the product on the storage tank. Refer to
install the product on a storage tank on page 9 .
9. Make sure that only approved persons are in the
work area.
10. Make sure that the ON/OFF switch is in the OFF
position before you connect the product to a power
supply.
11. Connect the product to a power source. Refer to
connect the product to a power source on page 12 .
To do a visual inspection
WARNING:
if the visual inspection gives indications of
damage or wear. If you are not sure about
the condition of the product or the lifting
equipment, speak to a competent person for
more inspections.
WARNING:
speed of the corrosion process.
2156 - 001 - 08.02.2024
Operation
Read and understand the
Make sure that the 6
To do
Maintenance
To
To
Do not use the product
Seawater increases the
WARNING:
other particles increase the speed of the
wear process.
•
Make sure that there is no wear or damage.
•
Make sure that there is no deformation. Deformation
decreases the material strength.
•
Make sure that there is no corrosion.
•
Make sure that there is no ice on the product.
•
Make sure that there are no loose bolts or nuts.
•
Make sure that no bearings or wheels are worn.
•
Examine all welded joints for cracks.
•
Make sure that no label is missing and that you can
read all labels.
•
Examine the steel wire ropes for wear and damage.
Refer to the operator's manual for the EBE 900 V
shot blaster.
•
Make sure that the lifting equipment has no cracks,
notches, grooves, corrosion or heat discoloration.
To do a pairing operation of the remote
control and the product
1. Install the antenna for the remote control at the
bottom of the electrical enclosure.
Sand, concrete dust, and
11
