Idiomas disponibles
Idiomas disponibles
2. Push the ON button for 3 seconds. The LED
flashes with a green light during startup. When the
LED flashes with a green light slowly, the pairing
operation is done.
To connect the product to a power
source
1. Connect the power plug of the product to a grounded
mains outlet or other power source.
2. Make sure that the mains voltage agrees with the
type plate on the product.
To start the product
1. Connect the product to a power source. Refer to
connect the product to a power source on page 12 .
2. Set the ON/OFF switch (A) in the ON position. The
green indicator for control voltage (B) comes on.
If the red indicator for phase sequence failure (C)
comes on, the phase sequence in the power plug
must be changed. Refer to
sequence on page 12 .
B
12
To change the phase
C
A
3. Push the ON button on the remote control to start
the remote control. The LED flashes with a green
light.
To change the phase sequence
1. Set the ON/OFF switch in the OFF position.
2. Disconnect the power plug from the power supply.
3. Turn the connectors in the power plug to change the
phase sequence.
To
To operate the product with the remote
control
Note:
The remote control is automatically de-
energized after a period of time if it is not used.
WARNING:
across the power supply cable.
1. Start the product. Refer to
page 12 .
2. Do a pairing operation of the remote control and the
product. Refer to
remote control and the product on page 11 .
Do not operate the product
To start the product on
To do a pairing operation of the
2156 - 001 - 08.02.2024
