Idiomas disponibles
Idiomas disponibles
Anleitung_STR_920_L_SPK7:_
6. Technical data
Motor rating
Motor speed
AC motor
Insulation material class
Protection type
Table size
Cut length
Jolly length
Max. workpiece thickness 90°
Max. workpiece thickness 45°
Diamond wheel
Weight
Laser class
Laser wavelength
Laser output
Laser power supply
Load factor:
A load factor of S2 20 min (intermittent periodic duty)
means that you may operate the motor continuously
at its nominal power level (2200 W) for no longer
than the time stipulated on the specifications label
(20 minutes ON period).
If you fail to observe this time limit the motor will
overheat. During the OFF period the motor will cool
again to its starting temperature.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029-1.
L
sound pressure level
pA
K
uncertainty
pA
L
sound power level
WA
K
uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 61029-1.
Vibration emission value a
≤ 2,5 m/s
h
K uncertainty = 1.5 m/s
2
07.02.2011
8:24 Uhr
Seite 17
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
2200 W S2 20 min
may change according to how the electric equipment
3000 rpm
is used and may exceed the specified value in
exceptional circumstances.
230 V ~ 50 Hz
Class B
The specified vibration value can be used to compare
the equipment with other electric power tools.
IP54
920 x 550 mm
The specified vibration value can be used for initial
920 mm
assessment of a harmful effect.
920 mm
Keep the noise emissions and vibrations to a
70 mm
minimum.
55 mm
Only use appliances which are in perfect working
order.
Ø 300 x Ø 25.4
Service and clean the appliance regularly.
78 kg
Adapt your working style to suit the appliance.
2
Do not overload the appliance.
Have the appliance serviced whenever
650 nm
necessary.
< 1 mW
Switch the appliance off when it is not in use.
2 x 1.5 V (AAA)
Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
7. Before using for the first time
95 dB(A)
The machine must be set up so that it stands
3 dB
firmly, i.e. it must be securely screwed to a work
108 dB(A)
bench, the base frame supplied in delivery, or
similar.
3 dB
All covers and safety devices must be correctly
attached before the machine is used for the first
time.
The cutting wheel must rotate smoothly.
Check that the voltage on the rating plate is the
same as your supply voltage before you connect
the machine to the power supply.
2
GB
17
