Idiomas disponibles
Idiomas disponibles
See chap. 2 for further details and prescriptions about the appliance positioning
and installation.
Wash all accessories in warm water with dish soap; rinse properly and wait for
complete drying before going on.
Connect the electric plug to a wall socket equipped with a regular differential
switch upstream.
Check that the cable does not come into contact with hot parts and that it is not
bent or pinched.
Start the COMPLETE STATIC OVEN program for 15 minutes as described below
with the appliance completely empty, i.e. without food or accessories inside;
this helps the spontaneous removal of the protective substances from the
internal walls and allows you to check for any manufacturing defects. During this
operation, the formation of a slight smoke or odor may occur: it is not dangerous
and does not indicate a malfunction and will dissolve spontaneously.
At the end of the program, open the door, check the integrity of the appliance
and wait for it to cool down. It is now possible to carry out the normal cooking
operations.
5. APPLIANCE USE
Cooking requires the food to be placed on the most suitable accessory for the type of
cooking desired (check the following chapter USE OF THE ACCESSORIES), inserted into
the appliance before any operation on the control panel. It is possible, and sometimes
necessary, to proceed with a preliminary heating of the cooking chamber, before
inserting the food, as described in the following PREHEATING chapter. At the end of
cooking, the appliance stops heating, produces three long beeps and goes into stand-
by; remove the food, let the appliance cool down, preferably with the door open,
before proceeding with cleaning.
After a short period of inactivity, even if connected to the electrical socket, the
appliance will be completely switched off. To switch to stand-by mode, press the
START button; the pushbutton light up and the program icons flash in sequence. Use
the UP and DOWN buttons to activate the display and select the desired program; each
time you press, the next or previous program icon flashes, indicating the selected
program. To confirm your selection, press the START button.
30
