DeWalt DCPS620 Manual De Instrucciones página 47

c. Remove pole saw from cut while it is running at full
speed. Stop pole saw by releasing trigger switch
Make sure saw chain has stopped before setting pole
saw down.
Saw Chain Sharpness

CAUTION: Sharp chain. Always wear protective gloves
when handling the chain. The chain is sharp and can
cut you when it is not running.
IMPORTANT: The chain cutters will dull immediately if they
touch the ground, stones, masonry or a nail while cutting.
To get the best possible performance from your chain saw it
is important to keep the teeth of the saw chain sharp. Chain
sharpening services are available from your nearest D
service center.
NoTE: Each time the saw chain is sharpened, it loses some
of the reduced kickback qualities and extra caution should
be used. It is recommended that a saw chain be sharpened
no more than four times.
Maintenance

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
The charger and battery pack are not serviceable.
Regular maintenance ensures a long effective life for the tool.
After every 10 minutes of use be sure to remove the battery
(be aware the chain and bar can be hot!) check the bar and
chain for correct tension and lubricate per Adjusting Chain
Tension and Chain Oiling.
Lubrication
Your power tool requires no additional lubrication.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the
risk of eye injury, always wear approved eye protection
when performing this procedure.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of the
tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Accessories

WARNING: Since accessories, other than those
offered by D WALT, have not been tested with this
e
product, use of such accessories with this tool could
be hazardous. To reduce the risk of injury, only
D WALT-recommended accessories/spare parts should
e
be used with this product.
Recommended accessories for use with your tool are
4 .
available at extra cost from your local dealer or authorized
service center.
Replacement chain and bar are available from your
nearest D WALT service center.
e
• DCPS620 requires replacement chain service part
number N603750 (accessory number DWO1DT608) .
Replacement 20 cm (8 inch) bar, service part
number N617853 (accessory part number DWZCSB8).
Repairs
The charger and battery pack are not serviceable.

WARNING: To assure product SAFETY and RELIABILITY,
WALT
e
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed by a
D WALT factory service center or a D
e
service center. Always use identical replacement parts.
Number of Drive Links
Recommended File Angle
Recommended File Size Round‑Shaped
SPECIFICATIONS
DCPS620
Guide Bar
Pitch
Drive Link Gauge
Aggressiveness
ENglIsh
WALT-authorized
e
20V Max*
8" (20 cm)
3/8" LP
0.043" (1.1 mm)
34
Low Kickback
30°
5/32" (4.0 mm)
(not included)
45