Idiomas disponibles
Idiomas disponibles
CLEANING
BLADE REMOVAL
Pliers recommended.
WARNING: To reduce the risk of electrical shock and injury to
persons, unplug the circulator before removing blade.
1. First, remove the nut from the shaft by turning the
nut clockwise to loosen. Remove the washer. Pull the
blade straight out from the shaft.
2. Wipe the Blade with a damp cloth. If your circulator
is used in a greasy environment, such as a kitchen,
mild soap or a common household cleaner may be
necessary. Do not use solvents. Do not place blade
in the dishwasher. The excessive heat can distort the
plastic.
3. To reattach - be certain the flat side of the shaft
aligns directly with the corresponding flat side on
the blade's socket. Push the blade all the way on
the shaft until it bottoms out. Do not use a hammer
as this could result in bearing damage. Reinstall
washer and nut.
14 English
Nut
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE AND SOLUTION
The unit fails to power on.
Unit is not plugged in. Plug Power Cord into electrical outlet.
Ensure unit fan speed setting is selected.
Plug fuse has blown. Replace fuse (See USER SERVICING INSTRUCTIONS).
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
The outlet is worn or damaged. Try another outlet or contact a qualified electrician.
Airflow is weak or slow.
Unit set to a low speed setting. Adjust to a higher speed setting.
Airflow is blocked. Remove obstruction.
Adjust direction of airflow towards the user.
GFCI has tripped.
Under certain conditions, it is possible for a reset GFCI (Ground Fault Circuit Interrupter) outlet to trip
when the user is changing speeds on a Vornado circulator. In this event, change to an outlet that is not
connected to a GFCI device. It could also indicate a weak or defective GFCI outlet. Contact a qualified
electrician to check the GFCI outlet.
15
English
