Idiomas disponibles
Idiomas disponibles
INSTALLATION
Installing the Unit
1. Cut the appropriate opening in the countertop for the unit
being installed (see below).
530 mm
(11-7/8")
330 mm
(13")
RCTHW-1B
Figure 10. Countertop Cutout Dimensions
NOTE: The countertop must be level to ensure proper draining
of the rectangular well.
NOTICE
Remote mounted control panels must have a minimum 152
mm (6") clearance from unit (not to exceed 1420 mm [56"]).
Mounting control panel closer may cause heat damage to
electrical system in control panel.
The remote mounted control box should be installed outside
of heat zone. Locating the control box inside heat zone will
cause the control(s) to overheat, malfunction, and fail.
2. Cut the appropriate opening for the control box in a vertical
surface at least 152 mm (6") from the unit, but no more
than 1420 mm (56") (see below).
RCTHW-1B
45 mm
(1-3/4")
Ø 4,5 mm
(3/16")
RHW-1B
42 mm
(1-11/16")
65 mm
(2-9/16")
Ø 4,5 mm
(3/16")
Figure 11. Control Box Cutout Dimensions
300 mm
11-7/8"
RHW-1B
130 mm
(5-1/8")
95 mm
(3-3/4")
157 mm
(6-3/16")
140 mm
(5-9/16")
150 mm
(5-15/16")
150 mm
(5-15/16")
NOTE: The electrical cord between the unit and the control box
is 1420 mm (56 inches) in length.
3. Guide the control box and electrical cords through the
countertop cutout and then lower the unit into the cutout.
Control Box
Cutout
Figure 12. Installing the Unit
4. Assemble the L-brackets to the
underside of the unit.
5. Tighten the L-bracket screws until
the top flange lies flat on the
countertop.
NOTICE
Do not use excessive force when
tightening mounting screws on
built-in units. This may damage unit
and/or countertop.
8
Countertop
Cutout
Countertop
Top Flange
Screw
Screw
L Bracket
L Bracket
Form No. RHWCEM-0910
