Idiomas disponibles
Idiomas disponibles
5.7. Adjusting the table height:
• To lift of lower the table, loosen the Table Clamp Lever, and turn the crank to reach the desired height.
• When the desired height is reached, tighten the Table Clamp Lever firmly so that the Table does not move
(Figure 8.10).
5.8. Adjusting the table angle:
• Loosen the bolt on the table (Figure 8.11).
• Adjust the table to the desired angle using a scale as a guide.
• Tighten the bolt (Figure 8.11).
M o v a b l e
Table
Clamp Lever
5.9. Adjusting the rotation of the table:
• Loosen the Table Clamp Lever (Figure 8.10).
• Rotate the table to the desired position.
• Tighten the Table Clamp Lever (Figure 8.12).
5.10. Adjusting the rotation of the FSC 25P movable table:
• Loosen the Moving Table Clamp Lever located at the bottom of the table.
• Rotate the table to the desired position up to 90°.
• Retighten the movable table clamp lever.
5.11. Adjusting the drilling depth:
• Indicate the depth of the hole on one of the sides of the workpiece.
• Loosen the bolt/nut of the depth gage (Figure 8.12).
• With the drill turned off, lower the drill bit so that it reaches the indication on the workpiece.
• Turn the depth gage indicator anti-clockwise until it stops and for the FSB 13P model, lower the lever.
• Tighten the depth gage lock bolt/nut.
•
The drill bit will stop at the adjusted depth level while no alteration is made on the depth gage (Fig. 8.13
and 8.14).
FIGURE 8.8
FIGURE 8.10
51
Belt
Belt guard cover
Guard
knob/bolt
FIGURE 8.9
Bolt
FIGURE 8.11
