Idiomas disponibles
Idiomas disponibles
EQUIPMENT AND MATERIAL INFORMATION
The equipment includes:
Compressor unit - Model: P0513EM F400
A1 - Switch
A2 - Air intake
A -
A3 - Air filter
A4 - Nebuliser holder
A6 - Power cable
Nebuliser and accessories - Model: RF8-3
B1 -Connecting tube (compressor/nebuliser unit)
B2 - RF8 Dual Speed Nebuliser
B2.1 - Lower part
B2.2 - Upper part with selector
B2.2.1 - Upper part
B2.2.2 - Selector switch support
B -
B2.2.3 - Speed selector
B3 - Mouthpiece
B4 - Paediatric SoftTouch mask
B5 - Adult SoftTouch mask
IMPORTANT NOTE: There is an identification label on the packaging, remove it and affix it in
the spaces provided on page 2. When replacing the Nebuliser and accessories, perform the
same procedure.
OPERATING INSTRUCTIONS
Before each use, wash your hands thoroughly and clean your appliance as described in the
section "HYGIENE PREPARATION". During application, it is recommended to adequately protect
e
oneself from drips. This appliance is suitable for the administration of medicinal substances
(solutions and suspensions), for which aerosol administration is envisaged; such substances
must in any case be prescribed by a doctor. In the case of substances that are too dense, dilution
with suitable saline solution may be necessary, as prescribed by a doctor.
1. Insert the plug of the power cable (A6) into a mains
socket corresponding to the voltage of the appli-
ance. It must be positioned in such a way that dis-
connection from the power grid is not difficult.
2. Reassemble the upper part with the selector
switch as shown in the connection diagram sect.
B2.2.
Attention, the selector support (B2.2.2) must fit
perfectly into the upper part (B2.2.1), to do this you
must align the arrow on the selector support with
the accessory coupling notch, see picture.
3. Add the medicine prescribed by the doctor into
the lower part (B2.1). Insert the upper part (B2.2)
into the lower part (B2.1), close the nebuliser by
turning the upper part (B2.2) clockwise.
4. Connect the accessories as shown in the 'Connection Diagram' on the cover.
he
s-
Information on materials
Polypropylene
Polypropylene +
Thermoplastic Elastomers
B2.2.1
19
B2.2.2
