Idiomas disponibles
Idiomas disponibles
Install
Ignitor
Battery
[] Unscrew
Ignitor Cap from
Control
Panel.
[] Place supplied AA battery
into the Ignitor
Slot with positive pole facing
you.
[] Position the Cap and Spring over the AA
battery and tighten onto Control
Panel.
Install
Cooking
Components
[]
Place the Heat Diffusers
above the
Burners.
[]
Place the Cooking
Grids on the ledge
above the Heat Diffuser.
[]
Place the Secondary
Cooking
Rack into
the holes on the upper left and right of
the Back Burner frame with the bottom
resting
in the slots on either side of
the Grill Bowl.
[]
Place the Griddle above the Side Burner.
Ignitor Slot
f
AA Battery_
Ignitor Cap
, "......
Spring
[]
[]
[]
[]
With the assistance
of another
person,
perform
this
Electrode
Check
before
proceeding.
This test will ensure that the Spark Electrode Tips
are properly positioned so your grill lights easily
and properly.
Be sure all Control
Knobs are set to
"OFF" and open the Grill Lid.
Have your assistant
stand
behind to the
right of the grill and look toward the front
of the grill bowl. Never
put your face
inside the Grill Head.
Press the Ignitor Cap. You should
hear
a "clicking"
sound.
Your assistant
should
see a blue spark
within each
Gas
Collector
Box. If a spark
is present the
Electrode
Tips are
properly
positioned.
If no spark
is seen, the Spark Gap
needs to be adjusted
as follows:
•
If the gap between
the Spark Elec-
trode Tip and Receiver
is more than
3/16"
use an adjustable
wrench
to
gently squeeze
the Gas Collector
Box
to narrow
gap.
• Recheck the Electrode again, if no
"clicking" sound is heard:
- AA Battery may be installed back-
wards.
- Electric wires may be loose. Remove
the AA Battery and inspect the Ignitor
Junction Box found behind the Control
Panel and reconnect any loose wires.
Secondary Cooking Rack
Cooking Grids
Heat
DiffUS_rokirng
Grid/Infrared
Griddle
3/16"
Spark Gap
Gas Collector
i!._
/ Box
J
ff
I
' Spark Electrode Tip
Spark Receiver
14
