Idiomas disponibles
Idiomas disponibles
FINISHING THE MOTOR INSTALLATION
CAUTION: To avoid possible electrical shock, be sure you have turned
Outlet Box
off the power at the main circuit panel.
Ceiling
Mounting
Receiver
Step 1. Tuck all the connections neatly into the ceiling outlet box.
Bracket
Screw
Step 2. Carefully raise the canopy up to the ceiling mounting bracket and place
one of the key hole slots in the canopy over the screw on the ceiling mounting
bracket. Rotate the canopy until the screw head locks in place at the narrow
section of the key hole. (Fig. 14)
Canopy
Step 3. Align the remaining circular hole in the canopy with the remaining
hole in the ceiling mounting bracket. Reinstall the screw you removed earlier
Screw
(HANGING THE FAN, Step 2/Fig. 5) into the aligned holes. Tighten both
Canopy Trim Ring
screws to secure. Attach the canopy trim ring to the screw heads by inserting
the screw heads into the canopy trim ring and rotating the canopy trim ring
Fig. 14
(clockwise).
NOTE: Adjust the screws as necessary until the canopy and canopy trim ring
are snug. (Fig. 14)
WARNING: Make sure the "Check Tab" at the bottom of the ceiling
mounting bracket is properly seated in the "Registration Slot"
on the side of the hanger ball before attaching the canopy to the
ceiling mounting bracket. Failure to properly seat the "Check Tab"
could damage the electrical wires when ceiling fan blade direction is
changed while the fan is running.
52" True | 13
