Bianchi SPECIALISSIMA RC Manual Suplementaria página 7

In the event of an accident or fall, the handlebar will almost certainly be involved and
will be subjected to high levels of stress and impact. In the event of any deep scratches
or cracks, replace the components.
WARNING!!
If the handlebar is damaged, stop using the Specialissima Comp bike immediately.
Do not use the Specialissima Comp bike until a specialist retailer has conducted a
full inspection and, if necessary, the handlebar has been replaced.
The gear/brake control levers are mounted on the handlebar using a clamp integrated
into the lever.
Pay close attention to the recommended positioning of the levers and respect the
positioning of the high grip zone (image 1A). Consult the lever product handbook for
the correct torque. To preserve the integrity of the handlebar bend, do not exceed the
maximum torque of 10 Nm.
THRU-AXLE
WARNING!!
Use caution and observe the following warnings.
Unlike quick-release systems, the thru-axles provided with this model are screwed directly onto the frame and fork dropouts using an M12
screw. Comply with the torques indicated on the thru-axles.
Female threads are housed in the frame and fork; the thru-axle with the male thread has a specific length to enable safe assembly of the
wheels. (images 1B and 1C)
The use of a thru-axle other than the one provided may result in the incorrect assembly of the wheel and may compromise the integrity
of the frame and fork.
Image 1B
WARNING!!
Always use the thru-axles provided with the model. The use of thru-axles other than those specified may cause the frame and/or
fork to break.
DANGER!
Incorrectly mounted wheels may result in falls and serious accidents. If in doubt, contact your specialist retailer.
DANGER!
Always comply with the torque levels specified on the thru-axles. Never exceed the maximum torque value indicated. Incorrect
tightening may damage the frame and fork.
image 1A
Image 1C
7