Idiomas disponibles
Idiomas disponibles
GAS CONNECTION
ONLY USE THE REGULATOR AND HOSE ASSEMBLY PROVIDED WiTH THiS
GRILL. REPLACEMENT
PRESSURE
REGULATORS AND HOSE ASSEMBLIES
MUST BE THOSE SUPPLIED
BY THE MANUFACTURER.
This is an LP (Liquefied
Petroleum Gas) configured
grill. Do not attempt
to use a natural gas
supply unless the grill has been reconfigured
for natural gas use.
The installation
of this appliance must conform with local codes or, in the absence of local
codes, with either the National Fuel Gas Code, ANSI Z223.1/NFPA
54, or CAN/CSA
B149.1,
Natural Gas and Propane Installation Code, or CAN/CSA
B149.2, Propane Storage and
Handling
Code.
LP TANK REQUIREMENTS
-
THE LP TANK USED WiTH YOUR GRILL MUST MEET THE FOLLOWING:
1, Measurement:
12" (30.5=cm) diameter x 18" (45.7-cm) tall.
2. Maximum
capacity:
20 Ibs. (9 kg).
3, Constructed
and marked in accordance
with the specification
for LP gas tanks of the U.S.
Department
of Transportation
(DOT) or the National Standard of Canada, CAN/CSA-B339,
Tanks, Spheres, and Tubes for the Transportation
of Dangerous
Goods. See LP tank collar
for marking.
4, Tank must be oriented to provide proper vapor withdrawal,
as shown in Fig, 14.
5. Includes a collar to protect the tank valve.
6, Has no dents or rust. A dented or rusty LP tank may be hazardous and should be checked
by your supplier.
7, Provides a shut=off valve terminating
in an LP gas tank valve outlet specified,
as applicable,
for connection
type QCC1 in the standard for compressed
gas tank valve outlet and inlet
connection
ANSI/CGA V-l.
8, Other tanks may be acceptable
for use with your grill provided
they are compatible
with the
tank retention means shown in Fig, 14.
LP TANK VALVE USED MUST MEET THE FOLLOWING:
1, Have type I outlet compatible
with regulator
provided.
2. Have safety relief valve.
3. UL=listed Overfill Protection
Device (OPD). This OPD safety feature is identified by a unique
triangular hand wheel. Only use tanks equipped
with this type of valve (as the figure shown
on the next page).
FOR YOUR SAFETY:
Ensure that the black plastic grommets
of the regulator
provided are in place and that the hose
does not come into contact with the heat shield or the grill head.
28
