Basic Saw Operations
Detent Override
To Engage:
1.
Lift the miter detent trigger 1 (Figure 24).
2.
Push the detent override clip 2 forward and latch in place
over edge. Release miter detent trigger 1.
3.
Move miter arm 3 to any position on the miter scale.
4.
Lock the miter lock knob 4 to retain miter position.
To Disengage:
5.
Loosen miter lock knob 4 and lift the miter detent trigger
1 to release the detent override clip 2.
Sliding Base/Fence Extension
Extend and use sliding base/fence when
WARNING
!
making severe bevel, severe miter or
compound cuts to provide sufficient (minimum 6") spacing
from hand to saw blade.
Sliding Base:
1.
Remove hex wrench from storage position on left rear
leg.
2.
Loosen two (2) socket cap screws 5 in sliding base
channel with the 6 mm hex wrench provided (Figure 25).
3.
Extend sliding base/fence 6 to the desired position.
4.
Tighten screws. Store hex wrench.
Sliding Fence:
1.
Unlock the fence locking lever 7 (Figure 26).
2.
Slide fence to proper position 8.
3.
Relock fence in place.
During transportation, sliding base and
CAUTION
!
fence should always be secured in the full
in position.
FIG. 24
3
FIG. 25
6
FIG. 26
8
54
2
4
1
5
7
