Idiomas disponibles
Idiomas disponibles
Description, Specifications and
Standard Equipment
Description
The RIDGID/Kollmann No. K-1500G Drain Cleaning
Machine is used for cleaning 1
This machine, using available kit, may be adapted to use
/
" sectional cable and tools to clean 1
7
8
itary, supply or process lines.
Specifications
Capacity........................1
Clutch...........................Instant acting
Cable Speed
Transmission has three FORWARD speeds and one
REVERSE. Use 3rd gear, 600 RPM, for most drain
cleaning applications. A slower cable speed, 2nd or 1st
gear, may be more effective depending on the nature of
the obstruction.
1st Gear .......................333 RPM
2nd Gear......................425 RPM
3rd Gear.......................500 RPM
REVERSE....................250 RPM
Engine..........................6 hp gasoline engine with re-
NOTE! Use only NO-LEAD gasoline in engine.
Weight..........................190 lbs.
Standard Equipment
A-1 ...............................Mitten (L.H.)
A-3 ...............................Tool Box
A-34-10 ........................Guide Hose (10 ft.)
A-2864 .........................Hex Key
No. 899 ........................Coupling Pin Key
Operating Instructions
Preparing Machine for Operation
WARNING
Do not start until instructed to do so.
4
K-1500G Drain Cleaning Machine
1
/
" through 10" lines.
2
/
" through 3" san-
1
2
1
/
" through 10" lines through
2
250' in distance using
7
/
8
1
1
/
" cable
4
versible gear transmission and
automatic throttle control
Ridge Tool Company • Elyria, Ohio • U.S.A.
It is very important to know approximate distance
from inlet to main sewer or septic tank. Overrunning
cable too far into main sewer or septic tank can
cause cables to knot up and prevent their return
through small line. If main is 12 inches or larger and
standard 1
1
/
4
more than 10 to 15 feet of overrun. When working
into a septic tank, do not allow more than 3 to 5 feet
overrun.
1. Position machine 14" -18" from line opening and at-
tach rear guide hose. Engage stabilizer legs.
NOTE! A Front Guide Hose A-20 is available for tight
areas which permits efficient line cleaning without
" or
whipping or kinking of cable.
2. Insert first cable into front of machine and push
through guide hose until 6" to 8" remains out of front
of machine.
Never couple more than one cable at a time.
3. Snap on straight auger, to go around elbow, and
check coupling,make sure it is secure.
NOTE! The Speed Coupler (Figure 1) is the easiest method
of changing tools and cables. Speed Couplers can
be added to all existing tools and cables.
To Couple Cable
and Tools
Snap Together
Figure 1 – Coupling and Uncoupling Cable Tools
Cable Applications
Standard Cable – Standard 1
straight lines from 3" through 6" and through fittings.
(Figure 2)
(F)
4" and 6" Tees
Figure 2 – Standard Cable Application
CAUTION
inch cable is being used, do not allow
WARNING
To Uncouple Cable and Tools
Insert Pin
1
/
" cable can be used in
4
(G)
3", 4" 6" Y's
3", 4" 6" Ells
Slide Apart
(H)
