CLEANING
PROCEDURES
A
CA UTION:
° Be sure ap#iance is offand all parts
are cool before handming or clean-
ing. This is to avoid damage
and
possibme burns,
° To prevent staining or discoloration.
clean appliance after each use.
° Ifa part is removed, be sure it is correctly
replace&
CONTROL
KNOBS
" Remove knobs in the OFF position by
pulling forward.
(Never
force the
knobs off.)
, Wash
in dishwasher
or soap and
water.
Do
not
use
abrasive
cleaners°
o Replace to OFF position.
(Never
hit
or use force to replace the knob.)
NOTE: The oven end griddge knobs
ore similar. However, the oven knob
has the
word
"Broil"
on it. The
small oven knob (select
models)
is
interchangeable
with
the griddle
knob.
CONTROL
PANEL
" Wipe
with
a damp
cloth.
Dry
thoroughly.
" Glass cleaners
may be used if sprayed
on a cloth
first.
Do
not
spray
direcdy
on the
panel
" Do not use other
cleaning
sprays,
abrasive cleaners or large amounts
of
water on the panel.
STAINLESS
STEEL
" DO
NOT
USE ANY
CLEANING
PROD UCT CONTAINING
CHLO-
RINE BLEACH.
° DO NOT USE ORANGE
OR ABRA-
SIVE CLEANERS.
" ALWAYS
WIPE WITH THE GRAIN
WHEN
CLEANING.
" Daily Cleaning/Light
Soil -Wipe
with one of the following
- soapy
water, white vinegar/water
solution,
Formula
409
Glass
and
Surface
Cleaner*
or a similar glass cleaner
-
using a sponge or soft cloth. Rinse
and dry. To polish and help prevent
fingerprints,followwith
StainlessSteel
Magic Spray (Jenn-Air Model A912,
Part No.
20000008)**.
" Moderate/Heavy
Soi[-Wipe
with
one of the following -gon Ami, Smart
Cleanser, or Soft Scrub* - using a
damp sponge or soft cloth. Rinse and
dry. Stubborn soils may be removed
with a damp Scotch-Brite*
pad; rub
evenly with the grain. Rinse and dry.
To restore luster and remove streaks,
follow with Stainless Steel Nagic Spray.
° DiscoJoration
-
Using a damp
sponge or soft cloth,wipewith
Cameo
Stainless Steel Cleaner*. Rinse imme-
diately and dry. To remove
streaks
and restore
luster, follow with Stain-
Jess Steel Hagic Spray.
OVEN
INTERIOR
(MANUAL
CLEAN
-- PORCELAIN
ENAMEL
FiNiSH)
° All
spi[[overs,
especially
acidic
spillovers,
should
be wiped
up
immediately
with
a dry cloth. To
prevent possible cracking or chipping
ofporcdain,
neverwipeoffawarm
or hot surfacewith
a damp cloth,
° Clean with soap and water.
Do not
allow food to bake on a second time.
° Heavy spi[lovers will require cleaning
with mild abrasive cleansers such as
S.O.S. or Bon AmP. Household am-
monia may be used to loosen soil.
Place 72 cup of household ammonia
in a glass dish on oven rack in a
dosed, cold oven overnight.
o To remove
difficult
stains, use an
oven cleaner
such as Easy-Off'Q Fol-
low oven cleaner directions.
Do not
spray gas burner, light bulb, tempera-
* Brand names are registered trademarks of the respective manufacturers.
** To order direct, ca[[ [-800-JENNAIR ([-800-536-6247).
J 2
ture
sensing
bulb,
door
gasket
or
exterior
of oven. Remove oven racks
before
spraying
with
oven
cleaner.
When
a commercial
cleaner
is used,
rinse oven with
a solution
of I table-
spoon vinegar
to I cup water.
OVEN RACKS
" Rub with a sponge or cloth using one
of the following
cleaners: Bon-Ami,
Soft Scrub or CometSQ Rinse and dry.
o For hard to
remove
soils, use a
dampened soap-filled scouring pad.
Rinse and dry.
OVEN
WINDOW
(SELECT
MODELS)
• Washwith soapandwaterorg[assdeaner.
Avoid using excessiveamounts of water.
Do not use abrasive
cleaners.
SURFACE
BURNERS
-- BURNER
CAP _
PORTED
BURNER
RiNG
-
MAY BE REMOVED
FOR
CLEANING.
• Wipe acidic foods and sugary
spills
imme-
diately with a dry cloth m prevent discol-
oration.
• Light soil - dean with hot soapy water
and a plastic scrubber.
• Moderate
soil - remove parts to a
countertop. Then clean:
[) spray with a household cleaner,
2) cover with plastic wrap for [5
minutes
3) wipe with a plastic scrubber.
er Cap
Ported
Borner
Ring
Burner
Jgnit_Tube
met Base