Black and Decker HH2455 Manual De Instrucciones página 4

Extension Cords
When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord wilt cause a drop in line voltage resulting in
loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next heavier
gauge. The smaller the gauge number, the heavier the cord.
Minimum Gage for Cord Sets
Volts Total Length of Cord in Feet
120V 0-25 26-50 51-100 101-150
(0-7,6m) (7,6-15,2m)(15,2-30,4m)(30,4-45,7m)
240V 0-50 51-100 101-200 201-300
(0-15,2m)(15,2-30,4m)(30,4-60,9m)(60,9-91,4m)
Ampere Rating
More Not more American Wire Gage
Than Than
0 6 18 16 16 14
6 10 18 16 14 12
10 12 16 16 14 12
12 16 14 12 Not Recommended
/_ SPECiFiC SAFETY WARNING
/'_WARNING: Some dust created by this product contains chemicals known to the
State of California to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• compounds in fertilizers
• compounds in insecticides, herbicides and pesticides
, arsenic and chromium from chemically treated lumber
To reduce your exposure to these chemicals, wear approved safety equipment such
as dust masks that are specially designed to filter out microscopic particles.
Functional Description
1. Blade
2. Guard
3. Bait Handle
4. Lock Button
5. Trigger Switch
6. Rotate Button
7. Pigtail Cord / Cord
Retainer
ASSEMBLY TOOLS REQUIRED (NOT SUPPLIED):
- Phillips Screwdriver
ATTACHING BAiL HANDLE TO TRIMMER
Z_WARNING: Only use with handle and guard properly assembled to hedge
trimmer. The use of the hedge trimmer without the proper guard or handle
provided may result in serious personal
injury.
The trimmer is shipped with the bail handle
tied to the trimmer. To attach the bail handle:
• Cut the zip tie which holds the handle to the
trimmer.
• Remove the phillips head screws from both
sides of the trimmer housing.
• Position the handle in place as shown in
figure A.