Idiomas disponibles
Idiomas disponibles
*
To prevent
damage
to the LCD monitor,
DO
NOT
... push it strongly or apply any shocks.
*
To proJong service
life
... avoid rubbing it with coarse cloth.
*
For safety, DO NOT
... open the camcorder's
chassis.
... disassemble
or modify the unit.
... short-circuit
the terminals
of the battery pack.
Keep it away from metallic objects when not in
use.
... allow inflammables,
water or metallic objects to
enter the unit.
... remove the battery pack or disconnect
the
power supply while the power is on.
... leave the battery pack attached when the
camcorder
is not in use.
o Avoid using the unit
... in places subject to excessive
humidity or dust.
... in places subject to soot or steam such as near
a cooking
stove.
... in places subject to excessive shock or
vibration.
... near appliances
generating
strong magnetic
or electric fields (speakers, broadcasting
antennas
etc.).
... in places subject to extremely high (over 40°C
or 104°F) or extremely low (under 0°C or 32°F)
temperatures.
*
DO NOT leave the unit
... in places of over 50°C (122°F).
... in places where humidity is extremely
low
(below 35%) or extremely high (above 80%).
... in direct sunlight.
... in a closed car in summer.
... near a heater.
,
To protect
the unit, DO NOT
... allow it to become wet.
... drop the unit or strike it against hard objects.
... subject it to shock or excessive vibration
during
transportation.
... keep the lens directed at extremely bright
objects for long periods.
... expose the lens to direct sunlight.
... carry it by holding the LCD monitor.
... swing it excessively
when using the hand strap
or the grip.
... swing the soft camera case excessively
when
the camcerder
is inside it.
*
Dirty heads can cause the following
problems:
... No picture during playback.
Blocks of noise appear during playback.
... During recording or playback, the Head Clog
Warning
indicator "_"
appears.
... Recording cannot be performed
properly.
In such cases,
use an optional
cleaning
cassette.
Insert it and play back. If the cassette
is used more than once consecutively,
damage
to the video heads
may result.
After the camcorder
plays back for about 20
seconds,
it stops automatically.
Also refer to
the cleaning
cassette's
instructions.
If, after using the cleaning
cassette,
the
problems
still exist, consult
your nearest
JVC
dealer.
Mechanical
moving
parts used to move the
video heads
and video tape tend to become
dirty and worn out over time. In order to
maintain
a clear picture
at all times, periodic
check-ups
are recommended
after using the
unit for about 1,000 hours.
For periodic
check-
ups please
consult your nearest
JVC dealer.
About
moisture
condensation
,
You have observed
that pouring
a cold
liquid into a glass will cause drops of
water
to form on the glass' outer surface.
This same
phenomenon
occurs
on the
head drum
of a camcorder
when it is
moved from a cool place to a warm
place, after heating
a cold room, under
extremely
humid
conditions
or in a place
directly subjected
to the cool air from an
air conditioner.
,
Moisture
on the head drum
can cause
severe damage
to the video tape, and can
lead to internal
damage
to the camcorder
itself.
