Idiomas disponibles
Idiomas disponibles
_
FRONT INSTALLATION
Install the front grille(packed separately) onto the
cabinet as foNows:
• Hook upper tabs of front gritle into slots on the
cabinet top. (FIG. 17)
• Push front griIWs tips towards the cabinet in order
to snap side tabs into the cabinet, (FIG, 17)
• Open the inlet grille. (FIG. 18)
• Install the screw (_TEM E) through the front grille.
(FIG. 18)
• Close inlet grille, (FIG, t9)
Front Installation
FiG. 17
_EM
E
Front Installation
FIG. 18
Front Installation
FIG. 19
IF AIR CONDITIONER
IS BLOCKED
BY
STORM WINDOW
FRAME
• If storm window presents interference,
fasten a 2"
wide wood strip to the inner window s]l! across the full
width of the sill. The wood strip should be thick
enough to raise the height of the window sill so that
the unit can be installed without interference
from the
the storm window frame. See FIG. 20.
Top d wood strip should be approximately 3/4"
higher than the storm window frame to help
condensation to drain properly to the outside,
• _nstal_ a _nd
w_d strip (approximately 6" long by
11/2" w ide and same thickr_ss as first strip) in the center
of the outer sill flush a_inst: the back of the inner sill,
Screw the Window I_king brackets into this strip.
This will raise the, Window locking bracket as shown
in FIG 20,
WOOD STRIP MOUNTED
ON TOP OF INNER SILl,,
3/4
CLEARANCE
SILL
LOCKIt@
BPACKEO , '
WOODSTRIP
FORWINDOW
LOCK!NG BRACKED
WINDOW
FRAME
SiLL
OUTSlOE FIG, 20
REMOVAL
FROM WINDOW
• Turn off and un#ug the air conditJonero
• Removethe front grille. See HOW TO REMOVETHE
FRONT GRILLE. Refer to _ge 13.
• Undrew the side screws that you installed in Step 15,
• Slide tie air condiflo_r out of the cabinet.
BE CAREFUL NOT TO DROP IT. Holdonto it firmlythe
who_eway sliding it old, Once removed, set it safety out
of the way,
• Removethe Window locking bracketfrom window
frame and the sash sea! from between the windows,
° Unscrew the side curtains from the window frame, Fold
them back to the sides of the cabinet.
• Removescrews attaching cabinet to inner sill. Be careDl
not to let _bJnet fail on_ screws are removed,
• Removecabinet from window opening.
• Place air conditioner into _bJnet. Reinstall side screws
and Front Grii_e,
° Place unit and all assembly h_dware in air conditioner
shipping carton, and store in clean, dry #ace.
• Air _nditioners
covered in this manual pose an
excessive weight hazard. Two or more people
are ne_ed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
° When handling the air conditioner, be careful to
avoid cuts from sharp metal fins on front and
rear coils.
• Make sure air conditioner does not fall during
removal.
-8-
