Kenmore 110.81422 Manual De Uso Y Cuidado E Instrucciones De Instalación página 18

Place drain hose in standpipe
or laundry tub
Drain
Make sure drain hose form is in correct position. Place
hose into standpipe (shown) or over side of laundry tub.
IMPORTANT: 4.5" (114 mm) of drain hose should be inside
standpipe; do not force excess hose into standpipe or lay
on bottom of laundry tub. Drain hose form must be used.
For use with floor drain: Do not install the drain hose form
onto the corrugated drain hose. You may need additional
parts. See Floor drain under "Alternate Parts".
CONNECT iNLET HOSES
Laundry Center must be connected to water faucets with new
inlet hoses with flat washers (not provided). Do not use old hoses.
NOTE: Both hoses must be attached and have water flowing to
inlet valves.
"1. insert washer into each hose _
|
% ........... _,
Insert a new fiat washer into each end of the inlet hoses (not
provided). Firmly seat the washers in the couplings.
2. Connect inlet hoses to water faucets
Make sure the washer basket is empty. Attach hose to the hot
water faucet. Screw on coupling by hand until it is seated on
the washer. Attach hose to the cold water faucet. Screw on
coupling by hand until it is seated on the washer. Using pliers0
tighten the couplings with an additional two-thirds turn.
iMPORTANT:
Do not overtighten or use tape or sealants
when attaching inlet hoses to faucets or to the Laundry Center.
Damage can result.
3. Clear water lines
Run water through both faucets and inlet hoses s into a
laundry tub, drainpipe, or bucket to get rid of particles in the
water lines that might clog the inlet valve screens. Check the
temperature of the water to make sure that the hot water hose
is connected to the hot water faucet and that the cold water
hose is connected to the cold water faucet.
18