GE 22 Manual Del Usuario E Instrucciones De Instalación página 19

Installation Instructions
[] REMOVE THE FREEZER DOOR
Tape the door shut with masking tape.
Remove tile hinge cover on top of tile freezer door
(on some models).
Remove tile two screws, then lift the hinge sn'aight
up to free tile hinge pin from tile socket in tile top
of tile door.
T°pHinge _ t
Remove the tape and tilt the door away from the
cabinet. Lift it off the center hinge pin.
Set the door on a non-scratching surface with
the inside up.
[] REMOVE THE REFRIGERATOR
DOOR
Tape the door shut with masking tape.
Remove the center hinge pin with a 3/4" socket.
Hinge Pin
II _._
Remove tile tape and tih tile door away from tile
cabinet. Lift the door straight off the bottom hinge
bracket.
Set the door on a non-scratching surface, with the
inside up.
CAUTION: Do not let door drop to the floor.
To do so could damage the door stop.
[] TRANSFER TOP HINGE TO
THE LEFT
Interchange hinge and screws at top right with screws
at the mp left of cabinet.
Do not tighten screws on hinge side at this time.
[]
TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
Remove tim base grille by pulling it straight out.
Using a socket drivel, move the bottom hinge bracket
from the right side to the left side.
NOTE: If the washer is not on the hinge bracket,
check to see if it is stuck to the bottom of the door.
19