3 Operation
ATTENTION
Property damage due to twisting of
the power tool
Cut curves at a low feed rate.
u
Do not fall below the power tool's mini-
u
mum radius.
Only apply the power tool to the work-
u
piece once it has reached full speed.
u
If the cutting line ends within the work-
piece: run the power tool backwards at
full speed for a few millimeters.
Only switch the power tool off when the
u
cutting process is finished.
To operate the power tool, see:
– Switching on and off
– Setting the speed
– Cutting off pipes flush
– Cutting profiles
D
– Checking charge
– Changing rechargeable battery
[} 158]
F
5 Troubleshooting
Problem
Tool is sluggish.
Tool does not switch on.
[} 158]
A
[} 158]
B
[} 158]
C
[} 158]
[} 158]
E
Cause
Blades are dull.
Rechargeable battery is
empty or defective.
Translation of the original operator's manual
4 Consumables and
accessories
4.1 Blade
The blades have two cutting edges. These
cannot be reground.
For gentle work and good cutting perfor-
mance, make sure that the blades are sharp,
and that they are changed promptly.
When cutting radii, the following must be
heeded:
– Do not twist the machine.
– Work only at a low feed rate.
For notes about selecting the correct tool, as
well as accessories, spare parts lists for
blades, tools, and rechargeable battery
packs, see:
S 114
(2A5)
4.2 Alternative rechargeable
batteries
This power tool can be used with all
CAS LIHD 12 V and CAS LI-Ion 12 V
rechargeable batteries.
Remedy
u
Swapping/changing blades
[} 159].
G
Changing rechargeable bat-
u
tery
[} 158].
F
EN
11
