Idiomas disponibles
Idiomas disponibles
4 - CONTROL UNIT
PD13 is provided with a display that, not only makes
programming simple, but also allows a continuous monitoring of
the input statuses; in addition, thanks to a menu structure, the
working schedule and the operation logic can be set easily.
In compliance with the European standards concerning
electrical safety and electromagnetic compatibility
(EN 60335-1, EN 50081-1 and EN 50082-1) it has been
equipped with the low voltage circuit total electric insulation
(motors included) from the network voltage.
Other characteristics:
•
Power supply protected from short circuits within the
controller, on the motors and on the connected accessories.
•
Adjustment of the power by partializing the current.
•
Detecting obstacles by monitoring the current on the motors
(current sensing probe and encoder)
•
Automatic learning of the limit switch position
•
Tests for safety devices (photocells, safety ribbons and mosfet)
before each opening.
•
Deactivation of safety inputs through the configuration
menu: no jumper is required for terminals concerning safety
devices that have not been installed, yet. You will only need
to disable this function from its relevant menu.
•
The device can operate without mains power, by using the
optional battery pack (code 161237).
•
Low voltage output that can be used for a signal light or a
24 V flashing light.
•
Auxiliary relay with programmable logic for courtesy light,
flashing light or other use.
•
ENERGY SAVING FUNCTION
•
Synchronized operation of two motors using the SYNCRO
optional module (compatible with the control units PD13
from version 1.1 onward)
m
WARNING: Installation of control unit and safety
devices must be carried out with power disconnected.
4.1 - POWER SUPPLY
The control unit must be fed by a 230V-50Hz electric line
(120V - 50/60Hz for the model 120V), protected by a differential
magnetothermal switch complying with the law provisions in
force.
Connect the power supply wires to terminals L and N on the
board located next to the transformer.
Connect the earth cable to terminal
4.2 - BATTERY POWER
In the case of an electricity black-out, the device may be powered
using a battery pack (accessory code 161237).
Connect the battery pack to the BATTERY terminals on the control
unit.
- 35 -
N
L
