Idiomas disponibles
Idiomas disponibles
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
CS3625DC / CS3630DC: Cordless Chain Saw
To reduce the risk of injury, user must read
instruction manual.
Do not use a power tool in the rain and
moisture or leave it outdoors when it is raining.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive
2012/19/EU on waste electrical and electronic
equipment and its implementation in
accordance with national law, electric tools
that have reached the end of their life must
be collected separately and returned to an
environmentally compatible recycling facility.
Read, understand and follow all warnings and
instructions in this manual and on the unit.
Always wear eye, head and ear protectors
when using this unit.
Beware of chain saw kickback and avoid
contact with bar tip.
Always use chain saw two-handed.
It is important that you wear the protective
clothing for feet, legs, hands, fore-arms and
head.
This chain saw is for use by trained tree service
operator only. Use without proper training can
result in severe injuries.
Chain oil delivery rate adjustment
Disconnect the battery
(Original instructions)
WHAT IS WHAT? (Fig. 1)
A: Battery (sold separately): Power source to drive the
unit.
B: Switch: Device activated by the fi nger.
C: Lock-off lever: Lever that prevents the accidental
operation of the trigger.
D: Chain brake: Device for stopping or locking the saw
chain.
E: Side cover: Protective cover to the guide bar, saw
chain, clutch and sprocket when the chain saw is in
use.
F: Nut: Nut for securing side cover.
G: Tensioning screw: Device for adjusting tension of saw
chain.
H: Front handle: Support handle located at or towards the
front of the main body.
I:
Rear handle (Top handle): Support handle located on
the rear of the main body.
J: Saw chain: Chain, serving as a cutting tool.
K: Guide bar: The part that supports and guides the saw
chain.
L: Spiked bumper: Device for acting as a pivot when in
contact with a tree or log.
M: Oil tank cap: Cap for closing the oil tank.
N: Oil sight glass: Window to check chain oil amount.
O: Hook: Tool for hanging the unit with rope etc.
P: Oil feeder: Container for oil.
Q: Chain case: Case for covering the guide bar and saw
chain when the unit is not being used.
R: Combi box spanner: The tool for removing or installing
a side cover and tensioning the saw chain.
WARNING
This
chain
designed especially for tree care and surgery. Only
persons trained in tree care and surgery may use
this saw. Observe all literature, procedures and
recommendations from the relevant professional
organization. Failure to do so constitutes a high
accident risk. We recommend always using a rising
platform for sawing in trees. Rappelling techniques
are extremely dangerous and require special training.
The operator must be trained in and familiar with the
use of safety equipment and working and climbing
techniques. Always use the restraining equipment
for both the operator and the saw.
GENERAL POWER TOOL SAFETY
WARNINGS
WARNING
Read all safety warnings, instructions, illustrations
and specifi cations provided with this power tool.
Failure to follow all instructions listed below may result in
electric shock, fi re and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
1) Work area safety
a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive
atmospheres, such as in the presence of
fl ammable liquids, gases or dust.
Power tools create sparks which may ignite the dust
or fumes.
7
saw
(CS3625DC
/
English
CS3630DC)
is
