Idiomas disponibles
Idiomas disponibles
PREPARATION
PLEASE REFER TO DIAGRAMS
(A, B, C...) AND ITEM NUMBERS
(1, 2, 3...) AS NOTED THROUGHOUT
MANUAL.
FOR EXAMPLE,
A-1 REFERS TO ITEM 1 IN FIGURE
A.
UNPACKING
Your mower has been completely
assembled
at the factory except for
the grass bag. Your Black & Decker cordless mower is shipped
with
the battery system fully assembled
and ready for use.
To remove mower from carton:
1. Remove the grass bag frame and cardboard
fillers.
2. Remove the mower from the carton and place all four wheels on the
ground or floor.
3. Check the carton thoroughly
and make sure there are no loose
parts.
To unfold handle:
Raise the handle section A-1 into place and secure by tightening
the two lower knobs A-2. Be careful not to pinch power cord.
ZL DANGER:
Sharp moving
blade.
For your
own safety
DO NOT use this mower without either the grass catcher, mulch insert,
or optional discharge
chute in operating
position, as serious
injury
could result.
ASSEMBLING
THE GRASS
CATCHER
(FIGURE
01, 02, 03, 04)
1. Before starting to assemble the grass bag to the frame, check that
the grass bag and frame are similar to figure C1.
2. Slide the grass bag onto the frame as shown in figure C2.
3. Assemble the top clips to the frame as shown in figure C3, then
assemble the two side clips and the bottom clip last.
4. Completely
assembled
grass catcher is shown in figure C4.
HANDLE
ADJUSTMENT
Your mower has a variable
height handle adjustment
feature.
To adjust
the handle position to suit your height preference,
use the following
procedure:
1. Remove both knobs B-1 on the middle part of the handlebars
and
remove the saddle bolts B-2.
2. Slide the upper handle into one of the 3 adjustment
positions
B-3,
aligning the holes in the upper and lower handles.
3. Insert the saddle bolts and install the knobs, tightening
securely.
The knobs should always be on the outside of the handles to avoid
interference
with the rear door and grass bag.
WHEEL
HEIGHT ADJUSTMENT
(1-3/4 IN.(44mm)
TO 3-1/2 IN. (89mm)
1. Before making any adjustments,
release switch lever to turn mower
off, wait for blade to stop, and remove safety key.
2. Your mower features the Black & Decker one touch wheel height
adjustment
system. This system will adjust all four wheels at the
same time.
3. To raise or lower the cutting height, place the palm of your hand on
the palm rest E-1 and with your fingers, squeeze upward on the
finger grip E-2 and hold.
4. While holding the finger grip up you can raise or lower the cutting
height. The mower has seven blade height adjustment
positions.
Refer to the scale F-1 and pointer F-2 at the front of the mower. The
pointer will indicate the height setting for cutting your lawn. This
setting can be a reference for the next time you want to cut your
lawn at the same height.
When you have the mower at the height you would like, hold it in
place with your left hand on the lower right handle bar and release
the finger grip with your right hand to lock the height adjust.
Note:
To ensure that the deck is securely locked in one of the seven
positions,
press down on the palm rest after releasing
the finger grip.
BATTERY
z_ CAUTION:
USE ONLY BLACK & DECKER APPROVED
REPLACEMENT
BATTERIES
- CONTACT YOUR LOCAL SERVICE
CENTER OR 1-800-544-6986.
The battery in your cordless
mower is a 24-volt sealed lead acid
system. There is no liquid contained
within the battery and the mower
can therefore be stored in any position without fear of leakage.
•
For optimal performance
the battery should be kept on constant
charge when not in use.
•
The battery prefers to be charged in a cool, dry place.
•
The battery does not need to be fully discharged
before recharging.
•
2 to 3 initial charging cycles may be required after purchase to
achieve maximum
run time capacity.
•
The battery can be safely stored down to -40°C (-40°F).
•
The battery is maintenance
free.
CHARGER
SAFETY
RULES
1. Plug charger directly into an electrical outlet. DO NOT ABUSE THE
CORD. Never carry charger by cord. Do not disconnect
the charger
from the outlet or mower by pulling it by the cord.
2.
Z_WARNING:
To reduce the risk of fire, electrical
shock, or
personal injury do not attempt to use this charger with any other
product. Likewise, do not attempt to charge the mower with any
other charger.
3. Do not service mower with charger or safety key installed.
4. Do not operate a damaged
charger. Replace damaged
cords or
charger immediately
at an authorized
Black & Decker service
center.
5. Always charge the mower in a dry area protected from the weather.
Do not expose the mower or charger to rain. Do not charge in wet
locations.
Do not charge mower when temperature
is above 40°C
(104°F) or below 5°C (41 °F).
6. Keep the mower and charger away from water, heat sources,
(such
as radiators,
heaters, stoves, etc.) flames, or chemicals.
Be careful
not to damage the charger cord, by keeping cord away from sharp
edges.
/_ WARNING: FIRE HAZARD
ALWAYS DISCONNECT
THE CHARGER
FROM THE POWER
SUPPLY (WALL OUTLET)
BEFORE
REMOVING
THE CHARGER
CONNECTOR.
UNDER CERTAIN CONDITIONS,
WITH THE
CHARGER
PLUGGED
IN TO THE POWER SUPPLY, THE
EXPOSED
CONNECTOR
CAN BE SHORTED
BY FOREIGN
MATERIAL
AND MAY CAUSE A FIRE. FOREIGN
MATERIALS
OF A
CONDUCTIVE
NATURE, SUCH AS, BUT NOT LIMITED TO, STEEL
WOOL, ALUMINUM
FOIL, OR ANY BUILD-UP
OF METALLIC
PARTICLES,
SHOULD
BE KEPT FROM THE CONNECTOR.
ALWAYS UNPLUG
CHARGER
BEFORE ATTEMPTING
TO CLEAN.
CHARGING
PROCEDURE
The charger for your mower is a specially designed 2-step charger.
Step 1 : The recharge cycle is indicated by the illuminated red light (D-1).
Step 2: The maintenance
cycle is indicated by the illuminated
green
light (D-2).
This cycle will maintain your mower in a fully charged condition.
1. Remove safety key D-6.
2. Plug the charger connector
D-3 into the receptacle
D-8 on the
mower. The charger connector
can only be plugged into the mower
receptacle
one way.
3. Insert the 120 volt plug D-4 of the charger D-5 into the wall
receptacle.
4. The red light on the charger should come on indicating
you have
power and the battery is being charged. The red light should
extinguish
and the green light will come on when charging is
complete
(takes approximately
9 hours to charge a fully discharged
mower).
5. It is recommended
to leave the mower on constant charge for
optimum performance
during the mowing season.
6. The charger supplied with this product is intended to be plugged in
such that it is correctly orientated
in a vertical or floor mount
position.
