Idiomas disponibles
Idiomas disponibles
Washer
Maintenance
Procedure
Your washer has a special cycle stored within the machine's
programming.
Pressing a specific combination
of buttons will
access this cleaning cycle, This cycle uses higher water volumes
in combination
with liquid chlorine bleach to thoroughly clean the
inside of your washing machine.
NOTES:
•
Read these instructions
completely
before beginning the
cleaning process.
If necessary, the cleaning cycle may be interrupted by
pressing the STOP button. This will stop the cycle. A RINSE &
SPIN cycle must then be run to thoroughly rinse the
remaining bleach from the unit. Failure to do so will cause
damage to the unit and clothing added to the next cycle.
Begin procedure
1. Open the washer door and remove any clothing or items from
the washer.
2. Be sure the door is closed.
3. Open the dispenser drawer and immediately add ¾ cup
(160 mL) of liquid chlorine bleach to the bleach compartment.
NOTE: Do not add any detergent to this cycle. Use of more
than ¾ cup (160 mL) of bleach will cause product damage
over time.
4=
5.
6=
Be sure dispenser drawer is closed.
To enter the cycle, a specific combination
of buttons must be
pressed.
•
Select the POWER button.
•
Select the RINSE & SPIN program.
•
Select the LOW Spin Speed.
•
Select WARM/COLD Water Temperature.
•
Disable the CYCLE SIGNAL.
•
Set DELAY WASH to 0 hours.
•
Push, the 2ND RINSE Option button 4 times within
5 seconds, to start the cycle. The door will lock.
NOTE: The basket will rotate, then the door will unlock,
lock again, and then the cycle will continue.
•
The machine will not fill, but the basket will rotate while
the washer runs a short sensing cycle. This will take
approximately
3 minutes.
The cycle will determine if items are in the washer.
a) If no items are detected in the washer, it will proceed
to Step 7.
b} If any items are detected in the washer, all the Cycle
lights will flash and the WASH, and CONTROLS
LOCKED lights will remain lit. The door will unlock.
•
Press STOP to cancel the failure code. Then
repeat steps 1,2 and 5, to start the cycle again.
7. Once the cycle has begun, allow the cycle to complete.
8. After the cycle is complete, leave the door open, slightly, to
allow for better ventilation and drying of washer interior.
Always do the following to maintain washer freshness
•
Use only HE High Efficiency detergent.
•
Leave the door slightly open after each cycle to allow for
better ventilation and drying of washer interior.
•
Repeat the cleaning procedure monthly, using ¾ cup
(160 mL) of liquid chlorine bleach.
•
If the procedure does not sufficiently improve the machine
freshness, please evaluate your installation and usage
conditions for other causes.
Cleaning
the exterior
Use a soft damp cloth or sponge to wipe up any spills.
Occasionally wipe the outside of your washer to keep it looking
new. Use mild soap and water. Do not use abrasive products.
Cleaning
the dispenser drawer
The dispenser drawer is removable for easy cleaning.
1. Unlock the dispenser drawer by pressing the Release Lever.
See "Using the Dispenser." Remove the drawer.
2. Remove the inserts (the siphon from the softener and bleach
compartments).
3. Wash the parts under running water.
NOTE: Do not wash components
in the dishwasher.
4. Replace the inserts and return the dispenser to the drawer.
Replace inlet hoses after five years of use to reduce the risk of
hose failure. Periodically inspect and replace inlet hoses if
bulges, kinks, cuts, wear or leaks are found.
When replacing your inlet hoses, record the date of replacement.
Install and store your washer where it will not freeze. Because
some water may stay in the hoses, freezing can damage your
washer. If storing or moving your washer during freezing weather,
winterize it.
Non-use
or vacation
care:
Operate your washer only when you are at home, If you will be on
vacation or not using your washer for an extended period of time,
you should:
Unplug washer or disconnect
power.
Turn off the water supply to the washer. This helps avoid
accidental flooding (due to a water pressure surge) while you
are away.
•
Slightly open door to provide ventilation.
To winterize
washer:
1. Put 1 qt (1 L) of R.V.-type antifreeze in the drum.
2. Run washer on a Drain & Spin cycle.
3. Unplug washer or disconnect
power.
4. Shut off both water faucets.
5. Disconnect
water inlet hoses from faucets and drain.
2O
